Specifications

ELECTRICALS

Before 17240 to 21035 100670-1 (Switch Only) or 102888 Switch Box Assembly

Beginning 20855 105869 Safe Start Plus and Cord Set

Beginning 21036 120228 Switch Assembly & 100846-16 Motor

BLADE GUIDES

To Serial Number 11751 102858 Frame Ratchet

102908 Guide Bracket Idle End

102912 Guide Bracket Drive End

101322 Roller Guide Assembly

From Serial Number 11752 105828 Frame Ratchet

105832 Idle Guide Bracket End

105830 Guide Bracket Drive End

101322 Roller Guide Assembly

BLADE GUARDS

To Serial Number 11885 102963 Blade Guard Idle End

102949 Blade Guard Drive End

102961 Pivot Rod

Current Idle Wheel Guard Assembly could replace old assembly

using the following parts:

105868 Idle Wheel Guard Assembly

105860 Roller Axle

WHEEL KITS

To Serial Number 22020 102931 Wheel and Handle Kit for ﬁ eld installation

1. Disconnect power.

2. Remove existing cover.

3. Remove wire nut (A) and add white pigtail with push connector.

4. Cut off red motor wire (B) from both ends of motor cord.

5. Connect black wire (C) from motor and wet saw pigtail (C) to toggle switch terminal (E).

6. Cut off existing terminal on black power wire (D) and replace with push terminal supplied.

7. Connect new white pigtail to relay coil terminal (F).

8. Connect black power wire (D) with new push terminal to relay line terminal (G)

9. Install cover on switch box.

10. Saw operation. Push reset button only after loss of power. Normal saw operation is by toggle switch.

122029 Switch Box Assembly

58B Service Parts Changes