Installation Guide

5. INDOOR UNIT INSTALLATION
4. INSPECTING AND HANDLING THE UNIT
At delivery, the package should be checked and any damage
should be reported immediately to the service agent.
When handling the unit, take into account the following:
Fragile, handle the unit with care.
Keep the unit upright in order to avoid compressor
damage.
Determine before hand the path which the unit is to be
brought in.
Move this unit in the originally package is possible.
When lifting the unit , always use protectors to prevent
belt damage and pay attention to the position of the
unit’s centre of gravity.
1
2
3
4
Keep the indoor unit, the outdoor unit, the power
supply wiring and transmission wiring at least 3.28ft
(1m) away from televisions and radios. This is to
prevent image interference and noise in those
electrical appliances. (Noise may be generated
depending on the conditions under which the electric
wave is generated, even if a distance of 3.28ft (1m) is
maintained.)
There is enough room for installation and maintenance.
(Refer to Fig.5-1 and Fig.5-2)
The outlet and the inlet are not impeded, and the
influence of external air is minimal.
The air flow can reach throughout the room.
The connecting pipe and drainpipe could be extracted out
easily.
There is no direct radiation from heaters.
5.1 Installation place
5.2 Install the main body
The indoor unit should be installed in a location that meets
the following requirements:
CAUTION
Fig.5-1
Fig.5-2
Fig.5-3
Fig.5-4
Fix the hook with a tapping screw onto the wall.(Refer to
Fig.5-3)
Hang the indoor unit on the hook.
(The bottom of body can touch with floor or suspended,
however the body must install vertically.)
≥3.9in/100mm
≥39.4in/
1000mm
≥3.9in/100mm ≥3.9in/100mm
Hook
Hook
Tapping
screw
Washer
＜0.24in/6mm
27.6in/700mm
8.3in/210mm
7.7in/195mm
7.7in/195mm
23.6in/600mm
7
Downloaded from www.Manualslib.com manuals search engine