Installation guide

b. Wireless Remote Control
The unit is factory equipped with a wire harness that has one end connecting to the receiver board (Display PCB) and the other
end is loose. See Fig. 32.
B
alo
&|O
wlol|* Loose End
nN} O
DISPLAY PCB |cpip-y “12
ob} 5—
2Pcb ~ 3 SpLE-2 C
JI 2 | Spans 6
s[4]3]2|i 1S B
TB2
gigigisig
ee Rte +
HIN [MH 1M |
@Lk | BLK
LITT COMM ia
7|6]s]4]al2|1 ']2]3]als 1f2[a]4]s
Ji J8 J5
A09547
Fig. 32 - Wire Harness
To modify the unit for use with wireless remote do the following:
a. Remove the cover of the Internal Control Panel to get access to the microprocessor board. See Fig. 33.
ee
=
=
INTERNAL CONTROL PANEL INTERNAL CONTROL PANEL
40KMCO18 40KMC024-036
40KMQ018-036
Capacitor
GMC board
Electric heater board
{only on models with electric heater)
Transformer
Holes for fixing panel in position
Emergency push-button
Fan connector
LED/RECEIVER connector
Float connector
Pump connector
Louver connector
€890
©o®
A07180
Fig. 33 - Internal Contro! Panel
b. Unplug the JS connector (A) from the board (see Fig. 32).
c. Plug the Loose end (B) into the JS Connector on the board
d. Reinstall the cover of the internal control panel