Installation guide

Zone Manager

If a Zone Manager is required, the following steps should be

performed at the same time the indoor control and power wiring

are being connected:

1. Plug the communication board to the J8 as shown in Fig. 33

2. Connect one end of the wire harness supplied with the Zone

Manager to the communication board.

3. Route the other end of the wire harness along the voltage

control to the back of the unit.

4. Connect the other end of the wire harness to the field sup-

plied wiring that will be connected to the zone manager as

shown in Fig. 33. (Shielded cables are required. Refer to

Zone Manager Installation Instructions for further informa-

tion.)

,,__.,

GREY

(_ [ BLUE @._CB

12v

a ®

O Main board

(_) Communication board (supplied with the kit)

(_) 5*cable wiring (supplied wilh the kit)

@ Auxiliary terminal block (supplied with the kit)

(_) Wiring by the installer

(_ Zone Manager terminal block (mounted on the Zone Manager)

O Indoor unit

I"-

/.,

T--- I

-4 II

1.' [

l, '

[1 [ I I !,,,,,]I ®

go o>

Fig. 33 - Wiring for Zone Manager

A09514