Owner's Manual

3
G
enera
l
i
n
f
ormat
i
on an
d
c
h
aracter
i
st
i
cs
IMPORTANT: Read this manual carefully before using the
appliance.
In case of main power supply failure, the autonomous operation of
the Room Controller is maintained for up to 2 hours.
S Pay special attention to maintaining a comfortable room
temperature above all for children and elderly or
handicapped persons.
S For correct use the conditioner must only operate at the
temperatures indicated in the “Operating Limits” table
included in the Technical manual.
S If the unit is made to operate beyond these limits faults
or water leaks may occur.
S Make sure the Room Controller control unit has not been
damaged during transport; if so, file an immediate claim
with the shipping company.
S Use the appliance only for the purpose it was designed
for .
S Dispose of packaging material in accordance with local
requirements.
S Do not open the appliance to avoid damage. In case of
malfunction, contact a qualified service engineer.
A = Display readout
B = Increase temperature /change louver setting button
C = Decrease temperature /change louver setting button
D = Fan selection button
E = Mode selection button A = Display readout
CDE
A B
Fig. 3 – Room Controller
1234
987
6
5
1=Automatic
2 =Off
3 = Temperature selected /
room temperature
4 = Set Temperature
5 = Operating position of the air louver
6 = Fan speed
7 = Heating
8 = Cooling
9 = Dehumidification only
Fig. 4 – Display of Selected Functions
Characteristics
S Single unit operation:
⎯ Ability to control one unit only.
S Grouping:
⎯ Ability to control 2 to 6 units with one Room
Controller.
S Operating modes:
⎯ Off, Heat, Cool, Dry, Auto, and Fan only.
S Fan speeds:
⎯ Low, Medium, High, and Auto.
S Louver control:
⎯ Auto and swing.
S Desired temperature:
⎯ Range between 17 and 32 _C(63and90_F).
S Room Thermistor Override:
⎯ Allows to use air sensor located in the Room
Controller instead of the one located into the unit.
S Non-- volatile memory:
⎯ Ability to retain user settings configurations during
power outages.
S Diagnostics:
⎯ Detects the fault of air sensor in the Room Controller.
⎯ “A1“ shown on the screen indicates this anomaly.
up
down
“UP” and “DOWN” Buttons
Buttons for raising or lowering the temperature or for selecting the
“AUTO“ or “SWING” louver mode.
Butt on for operat ion mode sel ec ti on.
Butt on for fan or louvr e sel ect i on.