Owner's Manual

8
5. Fan speed:
Choose the fan speed, using . When the selection has
been completed, press button for confirmation. The
fan speed icon will stop flashing.
6. Louver positioning:
Use , to select desired louver position. Press for
confirmation. Now all icons are fixed on display. To can-
cel selections made up to this point, push C; to cancel all
of the selected options once the timer has been set,
push and then C. The ON Timer settings are now
complete.
Setting the Off Timer — Set the Off Timer to
select a time for the system to turn off.
1. Press the Off Timer button.
The Off timer icon and numbers for a
time selection flash.
NOTE: This function can be set even if
the remote control is OFF.
2. Setting the Off time (buttons and
).
To set the Off time, press either button
or .
To move from hour to minute, press
.
Press again to confirm Off time
setting.
Setting the DAILY Timer — Push the but-
ton when the ON or OFF timer is active. The
icon will appear on display.
In this way the ON and OFF timer settings will be repeated
every day.
To deactivate the daily function, press again.
EXAMPLE 1: Combining the ON, OFF and DAILY timer
features.
To start the unit at 5:30 P.M. and stop at 10:30 P.M. for one
day only, complete the following steps:
1. Set the ON timer for 5:30 P.M.
2. Set the OFF timer for 10:30 P.M.
3. Select desired operating mode ( ).
EXAMPLE 2: To stop operation at 10:30 P.M. and start again
at 7:30 A.M. with the same operating mode, complete the fol-
lowing steps:
1. Set the OFF timer for 10:30 P.M. while the system is
operating.
2. Set the ON timer for 7:30 A.M.
For everyday operation to start at 5:30 P.M. and stop at
10:30 P.M. complete the following steps:
1. Set the ON timer for 5:30 P.M.
2. Set the OFF timer for 10:30 P.M.
3. Press the DAILY timer button .
CANCELLING THE ON, OFF AND DAILY TIMER
SETTINGS — To cancel the ON or OFF timer setting, press
the following buttons in order:
1. Button or ;
2. Button C.
To deactivate the Daily timer func-
tion, press .
NOTE: Everyday operation will remain
active until one of the two timers (ON
or OFF) is active.
Setting the Sleep Timer — Press this button
to set the SLEEP timer with the system on. The icon
will appear on the display.
This procedure permits setting the remaining unit operating
time until the Sleep mode is entered.
1. “1:hr” will be displayed together with the
icon.
2. Press . The display will show the
following settings in sequence: 1:hr, 2:hr,
3:hr, 4:hr, 5:hr, 6:hr, 7:hr, 8:hr and 9:hr.
3. Once the remaining operating hours have been selected
with either button or , press the button to
confirm.
4. When the SLEEP timer is set, the unit will control the set
temperature to avoid overcooling or overheating during
operation. The set temperature will change as in Fig. 10.
PM
PM
PM
AM
PM
PM
PM
PM