Owner's Manual

4
SETTING THE TIME ON THE REMOTE CONTROL
(Current Time Adjusting C and Reset Buttons) — Press cur-
rent time adjusting button C to adjust the current time. Press
the reset button with the tip of a pen or a paperclip if the re-
mote control is not operating properly or after replacing the
batteries.
1. With the remote con-
trol ON or OFF,
press C for at least
5 seconds.
2. The current hour flash-
es. Press either or
to set the current
hour. Press C again
to move to set the
minutes.
3. Once the current time
is set, press C to con-
firm it.
FAN SPEED — To select the Fan mode and change the Fan
Speed, follow the steps below:
1. Press the Mode button to select the Fan mode.
2. Press the Fan Speed button to select desired fan speed.
NOTE: If unit is operating in Dehumidification mode the fan
will only operate in low speed and cannot be changed.
TEMPERATURE SETTINGS — The temperature set point
can be easily changed by pointing the controller toward the unit
and pressing the increase/decrease temperature set point
buttons until the desired temperature appears on screen.
AIRFLOW DIRECTION — The louvers can be manually
operated by pressing the Louver button to change airflow
direction. Refer to Table 1 for louver positions.
1. Operating mode (from left to right)
Fan only
Heating (heat pump models only)
Automatic (heat pump models only)
Cooling
Dehumidification
2. Signal transmission symbol
3. Temperature set point selected
4. Address selected
5. Temperature unit of measurement (°C or °F)
6. Unit configuration
7. Low Battery indicator
8. Louver position
9. Fan speed
10. Turbo setting
11 . Economical setting
12. ON timer selected
13. Night timer active
14. DAILY timer active (Everyday)
15. ON timer and OFF timer or current time
16. OFF timer selected
17. Ionizer active
14
1
12
10
9
6
4
2
5
3
7
8
11
17
13
1615
Fig. 4 — Remote Control Display Icons