Owner's Manual

GB - 7
Infrared Remote
ENGLISH
After inserting the batteries in the remote control, the display
does not illuminate:
• The batteries are exhausted or the polarity is incorrect; replace
the batteries or check polarity.
When pressing the recessed clock adjustment button, the
hour figures on the display do not flash:
• The recessed button has not been pressed correctly; keep it
pressed for at least 5 seconds.
When pressing any button all symbols appear on the display:
• The remote control has been irreversibly damaged; replace with
a new one.
When pressing the start button, the unit does not
acknowledge the signal with a “beep”:
• The main switch is switched OFF, place the switch in the ON
position.
• The remote control batteries are exhausted; replace the
batteries.
• The remote control has not been pointed correctly at the unit
receiver; turn the remote control OFF and repeat the operation,
pointing the remote control in the correct direction.
• There are obstacles (curtains, partitions, etc.) between the
remote control and the unit; repeat the operation after having
removed the obstacles.
• The receiver on the unit or the remote control is exposed to
intense sun radiation; avoid direct sunlight on the unit, draw
curtains or shut shades, or move the remote control.
• Signal transmission is obstructed by severe electromagnetic
field interference; avoid sending signals when computers or
household appliances (food processors, coffee makers, etc.) are
operating close by.
Cellular or cordless telephones may also interfere with the
control.
When pressing the stop button the unit does not turn OFF
and does not acknowledge the signal with a “beep”:
• The remote control batteries are exhausted; replace the
batteries.
• The remote control has not been pointed correctly to the unit
receiver; turn the remote control OFF and repeat the operation,
pointing the remote control in the correct direction.
• There are obstacles (curtains, partitions, etc.) between the
remote control and the unit; repeat the operation after having
removed the obstacles.
• The receiver on unit or the remote control is exposed to intense
sun radiation; avoid direct sunlight on the unit, draw curtains or
shut shades, or move the remote control.
• Signal transmission is obstructed by severe electromagnetic
field interference; avoid sending signals when computers or
household appliances (food processors, coffee makers, etc.) are
operating close by.
Cellular or cordless telephones may also interfere with the
control.
When pressing any function button, the remote control
shows the function requested on the display, but the unit
does not acknowledge the signal with a “beep” and does not
carry out the function:
• The remote control batteries are exhausted; replace the
batteries.
• The remote control has not been pointed correctly to the unit
receiver; turn the remote control OFF and repeat the operation,
pointing the remote control in the correct direction.
• There are obstacles (curtains, partitions, etc.) between the
remote control and the unit; repeat the operation after having
removed the obstacles.
• The receiver on unit or the remote control is exposed to intense
sun radiation; avoid direct sunlight on the unit, draw curtains or
shut shades, or move the remote control.
• Signal transmission is obstructed by severe electromagnetic field
interference; avoid sending signals when computers or
household appliances (food processors, coffee makers, etc.) are
operating close by.
Cellular or cordless telephones may also interfere with the
control.
The remote control display does not change when any button
is pressed:
• The triangle symbol 2
is ON, whilst another signal is being
transmitted; wait for signal 2
to disappear and then repeat the
operation.
Troubleshooting