Owner's Manual

Infrared Remote
GB - 4
Use of the remote control
Current time adjusting and reset
buttons (buttons N and O)
Press current time adjusting button for at least 5 seconds to
adjust the current time.
Press reset button “O” with a sharp object if the remote control is
not operating properly or after replacing the batteries.
Setting current time
(button )
1. With the remote control ON or
OFF, press button
for at
least 5 seconds.
2. The time digits start to flash.
Press either button
or
to set the current hour.
Press button
to move to
minutes and set them.
3. For this setting always use
either button
or .
4. Once the current time is set,
press button
to confirm it.
Start / Stop
(button B)
When the air conditioner is not in operation, the remote control
readout will display the time of day only (in case other symbols are
lit, turn control off by pressing button
).
Press button
to start the air conditioner.
All selected and memorized functions will light up and appear; the
unit will operate according to the functions selected.
Press button
to stop the air conditioner.
All indicators on the unit will go out, and the control will display
only the current time.
If the unit does not stop, turn the control on (by pressing button
) and repeat the operation.
If button
(air conditioner starting) is pressed too soon after a
stop, the compressor will not start for 3/5 minutes due to the
inherent protection against frequent compressor cycling.
The unit will only emit a “beep”, when the signals are received
correctly.
The green unit ON lamp of the indoor unit display illuminates.
PM
F
F
Selection of the operating mode
(button A)
With this button the operating mode of the air conditioner can be
selected.
By repeatedly pressing this button the available modes will be
selected in sequence.
The choosen mode is shown as follows, while the unit will
acknowledge signal receipt with a confirming beep.
Indicated Symbol
Ventilation (fan only).
Heating (heat pump model only)
Automatic (heat pump model only)
Cooling with dehumidification.
Dehumidification only.
Temperature setting
UP
(button C)
DOWN
(button D)
Pressing the UP and DOWN buttons will increase or
decrease the temperature from the previously set value.
The unit will confirm signal receipt with a beep, and the value of
the set temperature on the display will change accordingly.
The temperature can be set between 63°F (17°C) and 90°F (32°C)
at 1 degree intervals.
In cooling mode, if the temperature selected is higher than the
room temperature the unit will not start; the same applies for the
heating mode, if the selected temperature is lower than the room
temperature.
Selecting direction of horizontal air
flow louver (button H)
The air flow direction can be adjusted up and down to optimize air
distribution in the room.
Press button
repeatedly to choose one of the following louver
positions:
Auto Louver: represented by repeating the following display
sequence:
Position 1-6: represented by the corresponding position on the
louver icon being visible. Position 6 points down:
Swing louver: represented by the louver icon cycling through 6
positions.
Selecting direction of vertical air flow
louver (button G)
This option is not available.