Owner's Manual

6
Remote Control Operation -- Quick Start
NOTE: When transmitting a command from the remote control to
the unit, be sure to point the control toward the LED display on the
front panel of the unit. The unit will confirm receipt of a command
by sounding an audible beep.
1. Turn the unit on by pushing the ON/OFF button.
2. Select the desired mode by pushing the mode button.
AUTO COOL DRY
FAN
ONLY
HEAT
A08301
NOTE: Cool only units have no heat mode.
3. Select the temperature set point by pointing the control to-
ward the unit and pressing the “TEMP +” or “TEMP --”
temperature set point buttons until the desired temperature
appears on screen.
4. Select the desired fan speed by pressing the FAN SPEED
button to select desired fan speed.
NOTE: If unit is operating in Dry mode, low fan speed will be
displayed and the fan speed cannot be changed.
5. Set the airflow direction. When the unit is turned on, the
louvers default to the cooling or heating position. The user
can adjust the default louver position by pushing the
“SWING” button. The louver will start to move. At this
point, the user can have the louver moving continuously or
stopped when the desired position is achieved by pushing
the “SWING” button.
Emergency Operation
If the remote control is lost, damaged, or the batteries are
exhausted, the AUTO button on the unit can be used to run the
unit.
Open the front cover panel and press the AUTO button once
briefly when the system is off.
To stop emergency operation, push the AUTO button once. The
emergency operation can also be stopped by pushing the
“ON/OFF”, “CLOCK”, “T--OFF”, or “T--ON” twice.
AUTO button
A08300
The following occurs when the AUTO button is pushed:
S 77_F(25_C) will be displayed on display panel.
S Unit will run in FAN ONLY mode if return air temperat-
ure is between 68_F(20_C) and 77_F(25_C).
S Unit will run in HEATING if return air temperature is
less than 68_F.
S Unit will run in COOLING if return air temperature is
greater than 77_F(25_C).
S Fan speed will be set to AUTO
S SWING will be on.
REMOTE CONTROL FUNCTIONS
The remote control is the interface between the user and the
high-- wall systems. Commands are entered by the user to control
the system. Any command that has been entered with the remote
control will remain in the memory until it is changed by the user
or the batteries are replaced.
NOTE: When entering commands, point the remote control in
the direction of the LED display on the front panel. The
will appear for a short period of time on the remote control
when the command is entered. The unit will only emit an
audible beep when the signals ar e received correctly.
On/Off Button
A08302
When the air conditioner is not in operation, the remote control
will display the last set point and time.
S Press the On/Off button to start the unit.
-- The unit will start in the last operating mode and set
point. The “OPER” indicator will appear. The “RUN”
indicator on the display panel turns green.
S Press button On/Off to stop the unit.
-- The “RUN” indicator light on the display panel will turn
red and the remote control will display the setpoint and
time. “OPER” will disappear.
NOTE: If the On/Off button is pressed too soon after a stop, the
compressor will not start for 3 minutes due to the inherent
protection against frequent compressor cycling.
Selecting an Operating Mode
Use the Mode button to select one of the available modes.
AUTO COOL DRY
FAN
ONLY
HEAT
A08303 /A08301
The selected mode will be displayed on the remote control and the
appropriate light will illuminate on the display panel. When the
unit is in AUTO, 77_F(25_C) will show on the display panel.
There is no icon for “FAN ONLY” on the display panel.