Technical data

Product overview 9/72
netRAPID Chip Carrier | Design Guide
DOC111004DG04EN | Revision 4 | English | 2014-09 | Released | Public © Hilscher, 2013-2014
Interface overview
The subsequent table lists interfaces and functions of the netRAPID Chip Carriers which are
currently supported by the licensed netRAPID Standard Loadable Firmware (NRPLFW). Note that
customized netRAPID firmware with extra functionalities will be available from Hilscher on request.
Standard functions
NRP 10-DPS NRP 10-CCS NRP 52-RE
Remark
8 bit parallel dual-port memory
✓ ✓ ✓
-
16 bit parallel dual-port memory
✓ ✓ ✓
-
Host interface
Serial dual-port memory (SPI)
✓ ✓ ✓
-
PROFIBUS DP (Slave)
✓
- - -
CC-Link (Slave) -
✓
- -
Communication
interface
Real-Time Ethernet (Slave) - -
✓
-
USB
✓ ✓ ✓
Default: USB is activated.
Diagnostic interface
UART - - -
Default: UART is deactivated.
The pins of the UART interface
are shared with the pins for the
SYNC interface.
Production interface JTAG - - -
For Hilscher development and
production only.
2x 4 bit (address switch)
✓ ✓
- -
Input
1x 4 bit (baud rate switch) -
✓
- -
Output 1 bit GPIO - - -
Standard firmware does not use
the GPIO.
SYNC interface SYNC0, SYNC1 - -
✓
Default: SYNC is activated
The pins of the SYNC interface
are shared with the pins for the
UART interface.
SYS-LED
✓ ✓ ✓
-
COM0, COM1
✓ ✓ ✓
-
LED
Link and Act - -
✓
-
Table 3: Interface and standard functions overview