Technical data

Technical data 54/72

netRAPID Chip Carrier | Design Guide

8 Technical data

8.1 CC-Link

8.1.1 netRAPID Chip Carrier NRP 10-CCS

NRP 10-CCS Parameter Value

Device identification Part number 7650.740

Communication interface Field bus CC-Link Slave

Transmission rate 156 kBit/s, 625 kBit/s, 2500 kBit/s, 5 MBit/s, 10 MBit/s

Interface Type RS-485

CC-Link Interface

Galvanic Isolation optically isolated

Communication controller Type netX 10

Memory FLASH 4 MB serial Flash EPROM

Type Parallel Dual-port memory or serial Dual-port memory (SPI)

Dual-port memory size 16 KB (14 address lines), where 8 KB used by firmware (13

address lines, lowest 8 KB)

Data width (parallel) 8 or 16 bit

Serial dual-port memory

interface

SPI Slave, mode 3 (CPOL = 1, CPHA = 1)

Serial transmission rate Max. 50 MHz

Host interface

Connector Type 76-pin solder contacts 1 mm with 1.5 mm grid

USB Signals at chip carrier (supported by standard firmware)

Available only if integrated in host system

Diagnostic Interface

UART RXD, TXD signals at chip carrier

(not supported by standard firmware)

Display LED Display Signals at chip carrier

SYS System Status

L RUN/L ERR Communication status

Voltage +3.3 V ± 5 % DC

Current at 3.3 V (typ.) 360 mA

Current at 3.3 V (max.) 710 mA

Power supply

Power Consumption (typ.) 1.2 W

Signal lines Voltage of IO signal lines +3.3 V ± 5 %

Ambient temperature

range for operation

0 … +70 °C Environmental conditions

Air flow 0.5 m/s

Dimensions L x W x H 32 x 32 x 4 mm

Weight Weight approx. 4 g

Table 40: Technical data NRP 10-CCS