Technical data

Evaluation Boards 45/72
netRAPID Chip Carrier | Design Guide
DOC111004DG04EN | Revision 4 | English | 2014-09 | Released | Public © Hilscher, 2013-2014
7.3 Operating elements of Evaluation Boards
7.3.1 Reset button (T1)
T1 Function
Resets the chip carrier.
When pressed, pin 41 is connected to GND.
Table 31: Reset button T1
Position in Figure 16 on page 39.
7.3.2 S-Boot button (T2)
T2 Function
Activating the serial boot mode via UART or USB. This signal is evaluated after a reset of the chip
during start-up phase. In serial boot mode, communication from the boot wizard application to the
chip is possible.
When pressed, pin 60 is connected to GND.
Table 32: S-Boot button T2
Position in Figure 16 on page 39.