Technical data

Evaluation Boards 40/72
netRAPID Chip Carrier | Design Guide
DOC111004DG04EN | Revision 4 | English | 2014-09 | Released | Public © Hilscher, 2013-2014
No. in
figure
Name Description Page
X11 JTAG interface, foil connector (for Hilscher development and production
only)
52
X3 Field bus interface measuring points 40
X30 PROFIBUS DP connector (NRPEB-DPS) 40
X50 CC-Link connector (NRPEB-CCS) 41
S0 Baud rate switch
CC-Link baud rate
(implemented on NRPEB-CCS only)
41
S1 Address switch
Station address * 1
S2 Address switch
Station address * 10
41 (CC-Link)
42 (PROFIBUS)
Table 22: Positions of NRPEB-CCS and NRPEB-DPS
7.1.1 Fieldbus measuring points (X3)
X3 Pin Signal Pin Pin assignment
1 FB1 68
2 FB2 69
3 FB3 70
4 FB4 71
5 FB5 72
6 FB6 73
7 FB7 74
8 FB8 75
9 FB9 76
10 GND
Pin assignment for CC-Link see section CC-Link interface
on page 30.
Pin assignment for PROF
IBUS see section PROFIBUS DP
interface on page 33.
Table 23: Pin assignment fieldbus interface X3
7.1.2 PROFIBUS DP (X30)
PROFIBUS DP pin assignment
PROFIBUS Pin Signal Description
3 FB3 / Rx/Tx + Receive- / Transmit data positive
4 FB2 / CNTR-P Control signal for repeater (direction control)
5 FB1 / ISO GND Data ground
6 FB9 / VP Power supply positive 5V for terminating resistor only.
8 FB7 / Rx/Tx - Receive- / Transmit data negative
9-pole sub-D
socket,
female
Shield PE Metal shell on PE
Table 24: PROFIBUS RS-485 pin assignment
Position in Figure 16 on page 39.