Technical data

Device type specific interfaces 30/72

netRAPID Chip Carrier | Design Guide

6.1.2 CC-Link interface

The pin assignment for CC-Link:

Pin Signal CC-Link Signal

68 FB1 DA

69 FB2 DB

70 FB3 DG

71 FB4 SLD

72 FB5 FG

73 FB6 not connected

74 FB7 not connected

75 FB8 not connected

76 FB9 not connected

Table 11: Pin assignment CC-Link interface of NRP 10-CCS

It is also strongly recommended to keep the length for the signal lines below 30 mm and to take

EMC aspects into account.

For details about the circuit for the host system see Figure 21: Schematic NRPEB-CCS and

NRPEB-DPS (Part 1) on page 62.

6.1.3 LEDs

Pin Signal No. Function

60 RDYn V11 System status LED (SYS) yellow

61 RUNn V11 System status LED (SYS) green

62 COM0_Gn V12 Communication status LED (COM0) green

CC-Link: L RUN

63 COM0_Rn V12 Communication status LED (COM0) red

CC-Link: L ERR

64 COM1_Gn V13 Communication status LED (COM1) green

CC-Link: not used

65 COM1_Rn V13 Communication status LED (COM1) red

CC-Link: not used

66 GPIO V1 yellow (560  to +3.3 V)

66 GPIO V1 green (560  to GND)

Table 12: Pin assignment LEDs (NRP 10-CCS)

For details about the circuit for the host system see Figure 21: Schematic NRPEB-CCS and

NRPEB-DPS (Part 1) on page 62.