Operating instructions



SW2 switch 1 of the CCM board in the “ON” status for the 4-20 mA signal

 

3.8.4 - Sensor installation

• Remove the clip (item 1) and the screw (item 2) that

hold the balancing line (item 3).

• Place the support supplied with the kit (item 4),

between the welded jumper and the clip that holds the

balancing line and re-attach everything.

• Place the sensor on the support, inserting it into the

recess and tighten it with the plastic collar.

The technical documentation for the leak detection module

is supplied in addition to the standard chiller documentation

that is in the control box. Here you will ﬁnd information

about module installation, usage precautions and operation,

and a detailled description as well as a trouble-shooting list.

Refrigerant detection sensor

Fixing of the detector on the support

Detector support

Balancing module

components

1. Clip

2. Fixing screw

3. Balancing line

4. Detector support