Specifications

41
4. To reassemble, bolt the bearing head to the crankcase.
Bolt torque:
• 06CC, 16 to 37 Cfm, and all 06D: 30 to 35 ft-lb.
(40 to 48 Nm)
• 06CC, 50 to 99 Cfm, and all 06E: 55 to 60 ft-lb.
(75 to 81 Nm)
5. Bolt the drive segment (replace if worn) to the crank-
shaft. Bolt torque:
• No. 10 Screw: 4 to 6 ft-lb. (5 to 8 Nm)
• 1.4 in. (6 mm) screw: 12 to 15 ft-lb. (16 to 20 Nm)
IMPORTANT: The 1/4 in. snorkle tube should face
away from the crankshaft (Fig. 6).
6. Insert the oil feed guide vane with the large diameter
inward. Place the oil feed vane spring over small
diameter of guide vane (do not install spring before
installing guide vane). Install pump cover plate (bolt
torque: 16 to 20 ft-lb. or 22 to 27 Nm).
NOTE: Do not over-torque or aluminum threads in
bearing head could be stripped.