Technical data

3-2 Installation and Service Guide N5250-90001
System Installation PNA Series Microwave Network Analyzer System
Receiving the System N5250A
Receiving the System
WARNING The N5260A millimeter head controller and the test head modules are sensitive to
electrostatic discharge (ESD). Ground your work station before unpacking and installing
the test head modules. See “Electrostatic Discharge Protection” on page 1-4.
The System as Shipped
The N5250C system components will arrive packaged separately. For a complete list of components shipped
with your system, refer to Table 3-1 on page 3-3.
When the entire shipment has arrived, contact Agilent Technologies to arrange for system installation, if
installation is available in your area. See “Agilent Support, Services, and Assistance” on page 5-4.
Keep the shipping containers until the system checklist has been completed, and the system has been
checked for physical damage.
If the shipping container is damaged or the packaging material shows signs of stress, notify the carrier as
well as the Agilent Technologies Customer Engineer. Keep the shipping materials for the carrier’s inspection.
Agilent Technologies will arrange for repair or replacement of damaged equipment without waiting for a
claim settlement from the carrier. Refer to “Agilent Support, Services, and Assistance” on page 5-4.
Agilent Technologies Customer Engineering
An Agilent Technologies Customer Engineer will be assigned to help you install the system. During
installation, the Customer Engineer will do the following:
• Unpack the system components.
• Complete the system checklist, see Table 3-1 on page 3-3.
• Connect the E8361C H11 PNA and the N5260A millimeter head controller.
• Install the millimeter-wave test head modules.
• Run a performance verification of the system, which includes a measurement calibration.
• Provide user training for one engineer.