User manual

52 Axxius 800 - Release 2.2
Quick Start
Provision a Unit
Set Up a Single Channel POTS card
Use the following commands to set up a POTS card.
Change the IP Address of the DS0 Management Channel
Use the following commands to change the IP over DS0 Management Channel for the
Axxius 800.
Set Up IP Addresses for Telnet CLI
Use the following commands to setup Telnet addresses for the Command Line Interface
(CLI).
Command Description
set {fxsPS-addr|fxsPSM-addr}
{ls|lsrb}
Set the signaling option for the port. See the
set (fxsPS or fxsPSM) command for details.
set {fxsPS-addr|fxsPSM-addr}
rxgain {n}
Set the receive gain/loss in dB. See the set
(fxsPS or fxsPSM) command for details.
set {fxsPS-addr|fxsPSM-addr}
txgain {n}
Set the transmit gain/loss in dB. See the set
(fxsPS or fxsPSM) command for details.
Command Description
set ipds0 down Set the DS0 management channel down
set ipds0 ip address
{ip-addr}
Set the DS0 management channel IP
address.
set ipds0 up Set the DS0 management channel up.
Command Description
set ethernet ip address
{ip-addr} {mask}
Set the Ethernet IP address, in the IP address
format. See the set ethernet ip address
command for more details.
set ip gateway {ip-addr} Set the IP gateway, in the conventional IP
address format. See the set ip gateway
command for more details.