Axxius 800 User Manual
Table Of Contents
- Axxius 800 User Manual
- Preface
- Table of Contents
- 1 - Base Platform
- 2 - Physical Installation
- 3 - Electrical Installation and Cabling
- 4 - Configuration
- 5 - CLI Commands
- Command Line Interface Help
- CLI Commands
- aco (Alarm Cut Off)
- add
- add (ds1) ais
- add (router) dhcp server option
- add (router) dns proxy
- add (router) remote
- add (router) snmp community
- add (router) snmp trap
- add (router) static dns host
- add (router) uploaduser
- add (router-lan) filter
- add (router-lan) secondary ip address
- add (router-lan) static
- add (router-wan) firewall
- add (router-wan) gre network
- add (router-wan) nat bypass
- add (router-wan) static
- add user
- alarms
- clear
- connect
- delete
- delete (ds1) ais
- delete (router) dhcp server option
- delete (router) dns proxy
- delete (router) remote
- delete (router) snmp community
- delete (router) snmp trap
- delete (router) static dns host
- delete (router) uploaduser
- delete (router-lan) filter
- delete (router-lan) secondary ip address
- delete (router-lan) static
- delete (router-wan) firewall
- delete (router-wan) gre network
- delete (router-wan) nat bypass
- delete (router-wan) static
- delete user
- disconnect
- exit
- install
- load
- log
- ping
- rename (router)
- reset
- restore
- rtrping
- set
- set alarms
- set autoexit
- set (bri)
- set (bri) mode
- set (bri) pmsync
- set cclabel
- set clock
- set clock (1 and 2)
- set date
- set (ds0)
- set (ds1)
- set (ds1 card)
- set (ds3)
- set ethernet ip address
- set external alarm
- set (fxo)
- set (fxsPS or fxsPSM)
- set id
- set idle
- set ip gateway
- set ipds0
- set key
- set login auth
- set login support
- set lsbackup
- set lsprotect enable/disable
- set lsprotect manual
- set lsprotect nonrevertive
- set lsprotect remove
- set lsprotect revertive
- set (ocudp) baud
- set (ocudp) loopback
- set (ocudp) loopdetect
- set (ocudp) mvec
- set (ocudp) secondary
- set (ocudp) selftest
- set (ocudp) up/down
- set (router) autologout
- set (router) default
- set (router) dhcp
- set (router) dns
- set (router) enhanced security
- set (router) lmi
- set (router) lmi poll
- set (router) login auth
- set (router) login prompt
- set (router) ntp
- set (router) password
- set (router) port
- set (router) ppp auth
- set (router) ppp security
- set (router) proxy
- set (router) reboot
- set (router) rip
- set (router) snmp
- set (router) stp
- set (router) syslog
- set (router-lan) filter forward
- set (router-lan) framing
- set (router-lan) gateway
- set (router-lan) ip address
- set (router-lan) ipx network
- set (router-lan) phy
- set (router-lan) rip
- set (router-lan) stp
- set (router-lan) up/down
- set (router-trunk) encapsulation
- set (router-trunk) multilink group
- set (router-trunk) speed
- set (router-trunk) up/down
- set (router-wan) dlci
- set (router-wan) gre
- set (router-wan) ip
- set (router-wan) ip address
- set (router-wan) ipx
- set (router-wan) nat
- set (router-wan) other
- set (router-wan) ppp
- set (router-wan) rip
- set (router-wan) stp
- set (router-wan) trunk
- set (router-wan) up/down
- set screen
- set snmp
- set time
- set user
- set (v35)
- set (v54)
- set verification
- show
- show (adpcm)
- show autoexit
- show (bri)
- show cclabels
- show clock
- show connect
- show connect adpcm
- show date
- show (ds0)
- show (ds1)
- show (ds3)
- show ethernet
- show external alarms
- show (fxo)
- show (fxsPS or fxsPSM)
- show id
- show image
- show impedance
- show ip
- show ipds0
- show login
- show lsprotect
- show ntp
- show (ocudp)
- show radius
- show (router)
- show (router) dhcp
- show (router) dns
- show (router) dns proxy
- show (router) lmi
- show (router) login
- show (router) ntp
- show (router) port
- show (router) ppp
- show (router) rip
- show (router) snmp
- show (router) stp
- show (router) syslog
- show (router) uploaduser
- show (router-lan)
- show (router-lan) filter
- show (router-lan) static
- show (router-lan) stp
- show (router-wan)
- show (router-wan) firewall
- show (router-wan) nat bypass
- show (router-wan) ppp
- show (router-wan) static ip address
- show (router-wan) static ip network
- show (router-wan) static ipx network
- show (router-wan) static mac address
- show (router-wan) static nat address
- show (router-wan) stp
- show (router-wan) trunk
- show screen
- show snmp
- show syslog
- show time
- show users
- show (v35)
- show (v54)
- status
- status (adpcm)
- status (adpcm) performance
- status (adpcm) performance history
- status (bri)
- status (bri) performance
- status (bri) performance history
- status clock
- status (ds0)
- status (ds1)
- status (ds1) performance
- status (ds1) performance history
- status (ds3)
- status (ds3) performance
- status (ds3) performance history
- status equipment
- status (fxo)
- status (fxsPS or fxsPSM)
- status ipds0
- status lsprotect
- status (ocudp)
- status (ocudp) performance
- status (ocudp) performance history
- status (router)
- status (router-lan)
- status (router-trunk)
- status sessions
- status (v54)
- store
- switch
- telnet
- trace route
- 6 - DS1 Controller Card
- 7 - DS3 Controller Card
- 8 - FXO Voice Card
- 9 - ISDN BRI Card
- 10 - OCU-DP Card
- 11 - Single Channel POTS Cards
- 12 - Power Supply
- 13 - Quad DS1 ADPCM Card
- 14 - Quad T1 & Quad DS1/E1 Card
- 15 - Terminal Server Router Card
- 16 - V.35/.54 Card
- 17 - Low Speed Protection Card
- 18 - Maintenance
- A - Regulatory Approvals
- B - SNMP Interface
- C - Loopback Tests
- Alarms
- Logs
- Status and Performance
- Overview
- DS1 Loopbacks
- V.35 Loopbacks
- V.35/V.54 Loop
- V.35/V.54 Service Card Description
- V.54 Loop
- V.54 Equipment Loopback
- 10Base-T
- 100Base-TX
- ADPCM
- Annex D
- Analog
- authentication
- authorization
- B-channel
- B8ZS
- backplane
- bandwidth
- Basic Rate Interface (BRI)
- BER
- BERT
- bipolar
- Bipolar Violation (BPV)
- bit
- Bit Error Rate Test (BERT)
- bit robbing
- bps
- BPV
- BRI
- bridge
- broadband
- C-bit Coding Violation (CCV)
- C-bit Errored Seconds (CES)
- C-bit Severely Errored Seconds (CSES)
- CDPD
- Central Office (CO)
- Challenge Handshake Authorization Protocol (CHAP)
- channel
- Channel Associated Signaling (CAS)
- CIDR
- Circuit Identifier
- Clear Channel
- CLI
- Classless Routing
- cold-standby
- Command Line
- Community Name
- Constant Bit Rate (CBR)
- CSU
- Customer Premise Equipment (CPE)
- Cyclic Redundancy Check (CRC)
- D4 Superframe (SF)
- Data Terminal Equipment (DTE)
- DDS
- DHCP
- download
- Drop & Insert (D&I)
- DS0
- DS1
- DS3
- DSU/CSU
- Dual Tone Multi- Frequency (DTMF)
- Dynamic Host Configuration Protocol (DHCP)
- E&M Signaling
- Earth ground
- Electro- magnetic Interference (EMI)
- Ethernet
- Facilities Data Link (FDL)
- File Transfer Protocol (FTP)
- filter
- frame
- frame relay
- FX
- FXO
- FXS
- gateway
- ground
- ground start (GS)
- GUI
- High Density Bipolar 3 (HDB3)
- High level Data Link Control (HDLC)
- hop
- host
- hot-standby
- hub
- IP
- Integrated Services Digital Network (ISDN)
- ISDN BRI
- internet
- Internet Protocol (IP)
- IP address
- jitter
- kbps
- kilobyte (kb)
- LAN (Local Area Network)
- Line Coding Violation (LCV)
- Line Errored Seconds (LES)
- Line Interface Unit (LIU)
- LLC
- LMI
- LMU
- LOF
- LOS
- loop back test
- loop start (LS)
- loopback
- LULT
- LUNT
- Management Information Base (MIB)
- Media Access Control (MAC)
- Mean Time Between Failures (MTBF)
- megabyte (MB)
- modem
- multiplexor
- network
- Network Address Translation (NAT)
- OOS
- OCU-DP
- P-bit Coding Violation (PCV)
- P-bit Errored Seconds (PES)
- P-bit Severely Errored Seconds (PSES)
- packet
- Packet InterNet Grouper (PING)
- Password Authentication Protocol (PAP)
- Peak Cell Rate (PCR)
- PLAR
- PMDL
- Point-to-Point Protocol (PPP)
- port
- protocol
- PVC
- RIP
- robbed bit
- router
- signal
- Simple Network Management Protocol (SNMP)
- slot
- span
- Spanning Tree
- star network
- static
- subnet mask
- subrate multiplexing
- subscriber line
- switch
- synchronous
- T1
- TBOS
- telnet
- TFTP
- Time Division Multiplexing (TDM)
- traffic
- Transmission Only (TO)
- trap
- Trivial File Protocol (TFTP)
- trunk
- trunk port
- upload
- V.90
- VC MUX
- Voice Over IP (VoIP)
- Wide Area Network (WAN)
- Wink
- Glossary
- Index

Glossary - 10 Axxius 800 - Release 2.2
Glossary
GUI
GUI Graphical User Interface, pronounced "GOOEY". A set of screen
presentations and metaphors that utilize graphic elements such as icons
in an attempt to make an operating system easier to use.
High Density
Bipolar 3
(HDB3)
A bipolar coding method that does not allow more than 3 consecutive
zeros.
High level Data
Link Control
(HDLC)
The HDLC protocol secures information in a data frame that allows
devices to control data flow and correct errors. For any HDLC
communications session, one station is designated primary and the other
secondary.
hop Each individual short trip that packets make from router to router, as they
are routed to their destination is a Hop.
host A computer that allows users to communicate with other host computers
on a network.
hot-standby In a redundant DS3 controller setup, the standby controller can be in two
states, the hot-standby signifies that the card is ready to take over for the
active and the switch will not affect service. Also see cold-standby.
hub A common connection point for devices in a network. Hubs are
commonly used to connect segments of a LAN. A hub contains multiple
ports.
IP Internet Protocol
Integrated
Services Digital
Network
(ISDN)
A technology offered by telephone carriers that allows for the rapid
transfer of voice and data. ISDN supports data transfer rates of 64 Kbps
(64,000 bits per second). Most ISDN lines offered by telephone
companies give you two lines at once, called B channels. You can use
one line for voice and the other for data, or you can use both lines for data
to give you data rates of 128 Kbps, slightly more than 2 times the data
rate provided by today’s fastest modems.