Axxius 800 User Manual

15-8 Axxius 800 - Release 2.2
Terminal Server Router Card
Card Configuration
Card Configuration
The Terminal Server Router card has the option of configuration through CLI or the
TSR Menu-driven software, which is accessed through Telnet. The following CLI
commands are all TSR related. For information on the TSR Menu-driven software, see
the Terminal Server Router User Manual.
NOTE: With this release TBOS features are set with the TSR Menu-driven
software. See the Terminal Server Router User Manual for more
information.
CLI Commands
Many of the router features can be configured directly with CLI commands. For
configuration of features not covered with CLI commands, the operator must use the
TSR Menu-driven software. For detailed information on the following TSR
commands, see Chapter 5, CLI Commands.
l add (router) dhcp server option
Enable add optional DHCP server attributes every time a DHCP client
discovery is initiated.
l add (router) dns proxy
Enable DNS proxy and add a remote DNS server address to the TSR card.
l add (router) remote
Add a remote WAN profile to the WAN profile table.
l add (router) snmp community
Add a SNMP community to an interface on the TSR card.
l add (router) snmp trap
To specify a destination to send SNMP trap messages.
l add (router) static dns host
Add a static DNS host record for resolving a domain name to an IP address
if the DNS server cannot provide the information.
l add (router) uploaduser
To specify a host that is allowed to upload configuration/software files.