Axxius 800 User Manual

9-6 Axxius 800 - Release 2.2
ISDN BRI Card
Card Configuration
Card Configuration
BRI card options are set with the Command Line Interface (CLI). For additional
information on these commands, see Chapter 5, CLI Commands.
CLI Commands
l connect
Creates two-way connections between channels
l disconnect
Removes a connection created by the connect command
l set (bri)
Setup of ISDN ports (up/down, threshold, call reference value)
l set (bri) mode
Set up ISDN cards mode of operation (3-DS0 or 4:1)
l set (bri) pmsync
Set up the BRI card source for performance monitoring synchronization
l set (ds0)
For cross-connect to ISDN, must be data type
l status (ds1)
Displays line status or performance statistics of a specific DS1
l set clock
Set the primary and secondary (clock1/clock2) master transmit clock source
l show (bri)
Displays BRI port configuration
l show clock
Displays actual clock source
l show (ds1)
Displays DS1 configuration
l status (bri)
Displays port status or performance statistics for the specified BRI
l status clock
Displays actual clock status and source