Axxius 800 User Manual
Table Of Contents
- Axxius 800 User Manual
- Preface
- Table of Contents
- 1 - Base Platform
- 2 - Physical Installation
- 3 - Electrical Installation and Cabling
- 4 - Configuration
- 5 - CLI Commands
- Command Line Interface Help
- CLI Commands
- aco (Alarm Cut Off)
- add
- add (ds1) ais
- add (router) dhcp server option
- add (router) dns proxy
- add (router) remote
- add (router) snmp community
- add (router) snmp trap
- add (router) static dns host
- add (router) uploaduser
- add (router-lan) filter
- add (router-lan) secondary ip address
- add (router-lan) static
- add (router-wan) firewall
- add (router-wan) gre network
- add (router-wan) nat bypass
- add (router-wan) static
- add user
- alarms
- clear
- connect
- delete
- delete (ds1) ais
- delete (router) dhcp server option
- delete (router) dns proxy
- delete (router) remote
- delete (router) snmp community
- delete (router) snmp trap
- delete (router) static dns host
- delete (router) uploaduser
- delete (router-lan) filter
- delete (router-lan) secondary ip address
- delete (router-lan) static
- delete (router-wan) firewall
- delete (router-wan) gre network
- delete (router-wan) nat bypass
- delete (router-wan) static
- delete user
- disconnect
- exit
- install
- load
- log
- ping
- rename (router)
- reset
- restore
- rtrping
- set
- set alarms
- set autoexit
- set (bri)
- set (bri) mode
- set (bri) pmsync
- set cclabel
- set clock
- set clock (1 and 2)
- set date
- set (ds0)
- set (ds1)
- set (ds1 card)
- set (ds3)
- set ethernet ip address
- set external alarm
- set (fxo)
- set (fxsPS or fxsPSM)
- set id
- set idle
- set ip gateway
- set ipds0
- set key
- set login auth
- set login support
- set lsbackup
- set lsprotect enable/disable
- set lsprotect manual
- set lsprotect nonrevertive
- set lsprotect remove
- set lsprotect revertive
- set (ocudp) baud
- set (ocudp) loopback
- set (ocudp) loopdetect
- set (ocudp) mvec
- set (ocudp) secondary
- set (ocudp) selftest
- set (ocudp) up/down
- set (router) autologout
- set (router) default
- set (router) dhcp
- set (router) dns
- set (router) enhanced security
- set (router) lmi
- set (router) lmi poll
- set (router) login auth
- set (router) login prompt
- set (router) ntp
- set (router) password
- set (router) port
- set (router) ppp auth
- set (router) ppp security
- set (router) proxy
- set (router) reboot
- set (router) rip
- set (router) snmp
- set (router) stp
- set (router) syslog
- set (router-lan) filter forward
- set (router-lan) framing
- set (router-lan) gateway
- set (router-lan) ip address
- set (router-lan) ipx network
- set (router-lan) phy
- set (router-lan) rip
- set (router-lan) stp
- set (router-lan) up/down
- set (router-trunk) encapsulation
- set (router-trunk) multilink group
- set (router-trunk) speed
- set (router-trunk) up/down
- set (router-wan) dlci
- set (router-wan) gre
- set (router-wan) ip
- set (router-wan) ip address
- set (router-wan) ipx
- set (router-wan) nat
- set (router-wan) other
- set (router-wan) ppp
- set (router-wan) rip
- set (router-wan) stp
- set (router-wan) trunk
- set (router-wan) up/down
- set screen
- set snmp
- set time
- set user
- set (v35)
- set (v54)
- set verification
- show
- show (adpcm)
- show autoexit
- show (bri)
- show cclabels
- show clock
- show connect
- show connect adpcm
- show date
- show (ds0)
- show (ds1)
- show (ds3)
- show ethernet
- show external alarms
- show (fxo)
- show (fxsPS or fxsPSM)
- show id
- show image
- show impedance
- show ip
- show ipds0
- show login
- show lsprotect
- show ntp
- show (ocudp)
- show radius
- show (router)
- show (router) dhcp
- show (router) dns
- show (router) dns proxy
- show (router) lmi
- show (router) login
- show (router) ntp
- show (router) port
- show (router) ppp
- show (router) rip
- show (router) snmp
- show (router) stp
- show (router) syslog
- show (router) uploaduser
- show (router-lan)
- show (router-lan) filter
- show (router-lan) static
- show (router-lan) stp
- show (router-wan)
- show (router-wan) firewall
- show (router-wan) nat bypass
- show (router-wan) ppp
- show (router-wan) static ip address
- show (router-wan) static ip network
- show (router-wan) static ipx network
- show (router-wan) static mac address
- show (router-wan) static nat address
- show (router-wan) stp
- show (router-wan) trunk
- show screen
- show snmp
- show syslog
- show time
- show users
- show (v35)
- show (v54)
- status
- status (adpcm)
- status (adpcm) performance
- status (adpcm) performance history
- status (bri)
- status (bri) performance
- status (bri) performance history
- status clock
- status (ds0)
- status (ds1)
- status (ds1) performance
- status (ds1) performance history
- status (ds3)
- status (ds3) performance
- status (ds3) performance history
- status equipment
- status (fxo)
- status (fxsPS or fxsPSM)
- status ipds0
- status lsprotect
- status (ocudp)
- status (ocudp) performance
- status (ocudp) performance history
- status (router)
- status (router-lan)
- status (router-trunk)
- status sessions
- status (v54)
- store
- switch
- telnet
- trace route
- 6 - DS1 Controller Card
- 7 - DS3 Controller Card
- 8 - FXO Voice Card
- 9 - ISDN BRI Card
- 10 - OCU-DP Card
- 11 - Single Channel POTS Cards
- 12 - Power Supply
- 13 - Quad DS1 ADPCM Card
- 14 - Quad T1 & Quad DS1/E1 Card
- 15 - Terminal Server Router Card
- 16 - V.35/.54 Card
- 17 - Low Speed Protection Card
- 18 - Maintenance
- A - Regulatory Approvals
- B - SNMP Interface
- C - Loopback Tests
- Alarms
- Logs
- Status and Performance
- Overview
- DS1 Loopbacks
- V.35 Loopbacks
- V.35/V.54 Loop
- V.35/V.54 Service Card Description
- V.54 Loop
- V.54 Equipment Loopback
- 10Base-T
- 100Base-TX
- ADPCM
- Annex D
- Analog
- authentication
- authorization
- B-channel
- B8ZS
- backplane
- bandwidth
- Basic Rate Interface (BRI)
- BER
- BERT
- bipolar
- Bipolar Violation (BPV)
- bit
- Bit Error Rate Test (BERT)
- bit robbing
- bps
- BPV
- BRI
- bridge
- broadband
- C-bit Coding Violation (CCV)
- C-bit Errored Seconds (CES)
- C-bit Severely Errored Seconds (CSES)
- CDPD
- Central Office (CO)
- Challenge Handshake Authorization Protocol (CHAP)
- channel
- Channel Associated Signaling (CAS)
- CIDR
- Circuit Identifier
- Clear Channel
- CLI
- Classless Routing
- cold-standby
- Command Line
- Community Name
- Constant Bit Rate (CBR)
- CSU
- Customer Premise Equipment (CPE)
- Cyclic Redundancy Check (CRC)
- D4 Superframe (SF)
- Data Terminal Equipment (DTE)
- DDS
- DHCP
- download
- Drop & Insert (D&I)
- DS0
- DS1
- DS3
- DSU/CSU
- Dual Tone Multi- Frequency (DTMF)
- Dynamic Host Configuration Protocol (DHCP)
- E&M Signaling
- Earth ground
- Electro- magnetic Interference (EMI)
- Ethernet
- Facilities Data Link (FDL)
- File Transfer Protocol (FTP)
- filter
- frame
- frame relay
- FX
- FXO
- FXS
- gateway
- ground
- ground start (GS)
- GUI
- High Density Bipolar 3 (HDB3)
- High level Data Link Control (HDLC)
- hop
- host
- hot-standby
- hub
- IP
- Integrated Services Digital Network (ISDN)
- ISDN BRI
- internet
- Internet Protocol (IP)
- IP address
- jitter
- kbps
- kilobyte (kb)
- LAN (Local Area Network)
- Line Coding Violation (LCV)
- Line Errored Seconds (LES)
- Line Interface Unit (LIU)
- LLC
- LMI
- LMU
- LOF
- LOS
- loop back test
- loop start (LS)
- loopback
- LULT
- LUNT
- Management Information Base (MIB)
- Media Access Control (MAC)
- Mean Time Between Failures (MTBF)
- megabyte (MB)
- modem
- multiplexor
- network
- Network Address Translation (NAT)
- OOS
- OCU-DP
- P-bit Coding Violation (PCV)
- P-bit Errored Seconds (PES)
- P-bit Severely Errored Seconds (PSES)
- packet
- Packet InterNet Grouper (PING)
- Password Authentication Protocol (PAP)
- Peak Cell Rate (PCR)
- PLAR
- PMDL
- Point-to-Point Protocol (PPP)
- port
- protocol
- PVC
- RIP
- robbed bit
- router
- signal
- Simple Network Management Protocol (SNMP)
- slot
- span
- Spanning Tree
- star network
- static
- subnet mask
- subrate multiplexing
- subscriber line
- switch
- synchronous
- T1
- TBOS
- telnet
- TFTP
- Time Division Multiplexing (TDM)
- traffic
- Transmission Only (TO)
- trap
- Trivial File Protocol (TFTP)
- trunk
- trunk port
- upload
- V.90
- VC MUX
- Voice Over IP (VoIP)
- Wide Area Network (WAN)
- Wink
- Glossary
- Index
6-4 Axxius 800 - Release 2.2
DS1 Controller Card
Technical Specifications
Technical Specifications
Product Includes
l Built-in non-blocking 1/0 Digital Cross-connect System for up to 36 T1 ports
l Robbed-bit (voice) and clear channel (data) signaling on the same DS1
l Integral quad T1 ports that support drop-and-insert applications
l T1.231 performance monitoring statistics: 96 15-minute segments
(24 hour period)
l Performance report messages
l Front-panel LED indicators for DS1 status, major and minor alarms, and alarm
cut-off status are located on the Control Panel Interface card
l Controller support for Terminal Server Router card code download through its
Ethernet management port
l Configurations automatically stored in non-volatile memory
l SNMP agent, supporting MIB objects:
- RFC 1213 (MIB-II) - RFC 2233 (IF-MIB)
- RFC 1659 (V.35) - RFC 2494 (DS0-MIB)
- RFC 1907 (SNMPv2-MIB) - RFC 2495 (DS1/E1-MIB)
- RFC 2011 (IP-MIB)