Axxius 800 User Manual
Table Of Contents
- Axxius 800 User Manual
- Preface
- Table of Contents
- 1 - Base Platform
- 2 - Physical Installation
- 3 - Electrical Installation and Cabling
- 4 - Configuration
- 5 - CLI Commands
- Command Line Interface Help
- CLI Commands
- aco (Alarm Cut Off)
- add
- add (ds1) ais
- add (router) dhcp server option
- add (router) dns proxy
- add (router) remote
- add (router) snmp community
- add (router) snmp trap
- add (router) static dns host
- add (router) uploaduser
- add (router-lan) filter
- add (router-lan) secondary ip address
- add (router-lan) static
- add (router-wan) firewall
- add (router-wan) gre network
- add (router-wan) nat bypass
- add (router-wan) static
- add user
- alarms
- clear
- connect
- delete
- delete (ds1) ais
- delete (router) dhcp server option
- delete (router) dns proxy
- delete (router) remote
- delete (router) snmp community
- delete (router) snmp trap
- delete (router) static dns host
- delete (router) uploaduser
- delete (router-lan) filter
- delete (router-lan) secondary ip address
- delete (router-lan) static
- delete (router-wan) firewall
- delete (router-wan) gre network
- delete (router-wan) nat bypass
- delete (router-wan) static
- delete user
- disconnect
- exit
- install
- load
- log
- ping
- rename (router)
- reset
- restore
- rtrping
- set
- set alarms
- set autoexit
- set (bri)
- set (bri) mode
- set (bri) pmsync
- set cclabel
- set clock
- set clock (1 and 2)
- set date
- set (ds0)
- set (ds1)
- set (ds1 card)
- set (ds3)
- set ethernet ip address
- set external alarm
- set (fxo)
- set (fxsPS or fxsPSM)
- set id
- set idle
- set ip gateway
- set ipds0
- set key
- set login auth
- set login support
- set lsbackup
- set lsprotect enable/disable
- set lsprotect manual
- set lsprotect nonrevertive
- set lsprotect remove
- set lsprotect revertive
- set (ocudp) baud
- set (ocudp) loopback
- set (ocudp) loopdetect
- set (ocudp) mvec
- set (ocudp) secondary
- set (ocudp) selftest
- set (ocudp) up/down
- set (router) autologout
- set (router) default
- set (router) dhcp
- set (router) dns
- set (router) enhanced security
- set (router) lmi
- set (router) lmi poll
- set (router) login auth
- set (router) login prompt
- set (router) ntp
- set (router) password
- set (router) port
- set (router) ppp auth
- set (router) ppp security
- set (router) proxy
- set (router) reboot
- set (router) rip
- set (router) snmp
- set (router) stp
- set (router) syslog
- set (router-lan) filter forward
- set (router-lan) framing
- set (router-lan) gateway
- set (router-lan) ip address
- set (router-lan) ipx network
- set (router-lan) phy
- set (router-lan) rip
- set (router-lan) stp
- set (router-lan) up/down
- set (router-trunk) encapsulation
- set (router-trunk) multilink group
- set (router-trunk) speed
- set (router-trunk) up/down
- set (router-wan) dlci
- set (router-wan) gre
- set (router-wan) ip
- set (router-wan) ip address
- set (router-wan) ipx
- set (router-wan) nat
- set (router-wan) other
- set (router-wan) ppp
- set (router-wan) rip
- set (router-wan) stp
- set (router-wan) trunk
- set (router-wan) up/down
- set screen
- set snmp
- set time
- set user
- set (v35)
- set (v54)
- set verification
- show
- show (adpcm)
- show autoexit
- show (bri)
- show cclabels
- show clock
- show connect
- show connect adpcm
- show date
- show (ds0)
- show (ds1)
- show (ds3)
- show ethernet
- show external alarms
- show (fxo)
- show (fxsPS or fxsPSM)
- show id
- show image
- show impedance
- show ip
- show ipds0
- show login
- show lsprotect
- show ntp
- show (ocudp)
- show radius
- show (router)
- show (router) dhcp
- show (router) dns
- show (router) dns proxy
- show (router) lmi
- show (router) login
- show (router) ntp
- show (router) port
- show (router) ppp
- show (router) rip
- show (router) snmp
- show (router) stp
- show (router) syslog
- show (router) uploaduser
- show (router-lan)
- show (router-lan) filter
- show (router-lan) static
- show (router-lan) stp
- show (router-wan)
- show (router-wan) firewall
- show (router-wan) nat bypass
- show (router-wan) ppp
- show (router-wan) static ip address
- show (router-wan) static ip network
- show (router-wan) static ipx network
- show (router-wan) static mac address
- show (router-wan) static nat address
- show (router-wan) stp
- show (router-wan) trunk
- show screen
- show snmp
- show syslog
- show time
- show users
- show (v35)
- show (v54)
- status
- status (adpcm)
- status (adpcm) performance
- status (adpcm) performance history
- status (bri)
- status (bri) performance
- status (bri) performance history
- status clock
- status (ds0)
- status (ds1)
- status (ds1) performance
- status (ds1) performance history
- status (ds3)
- status (ds3) performance
- status (ds3) performance history
- status equipment
- status (fxo)
- status (fxsPS or fxsPSM)
- status ipds0
- status lsprotect
- status (ocudp)
- status (ocudp) performance
- status (ocudp) performance history
- status (router)
- status (router-lan)
- status (router-trunk)
- status sessions
- status (v54)
- store
- switch
- telnet
- trace route
- 6 - DS1 Controller Card
- 7 - DS3 Controller Card
- 8 - FXO Voice Card
- 9 - ISDN BRI Card
- 10 - OCU-DP Card
- 11 - Single Channel POTS Cards
- 12 - Power Supply
- 13 - Quad DS1 ADPCM Card
- 14 - Quad T1 & Quad DS1/E1 Card
- 15 - Terminal Server Router Card
- 16 - V.35/.54 Card
- 17 - Low Speed Protection Card
- 18 - Maintenance
- A - Regulatory Approvals
- B - SNMP Interface
- C - Loopback Tests
- Alarms
- Logs
- Status and Performance
- Overview
- DS1 Loopbacks
- V.35 Loopbacks
- V.35/V.54 Loop
- V.35/V.54 Service Card Description
- V.54 Loop
- V.54 Equipment Loopback
- 10Base-T
- 100Base-TX
- ADPCM
- Annex D
- Analog
- authentication
- authorization
- B-channel
- B8ZS
- backplane
- bandwidth
- Basic Rate Interface (BRI)
- BER
- BERT
- bipolar
- Bipolar Violation (BPV)
- bit
- Bit Error Rate Test (BERT)
- bit robbing
- bps
- BPV
- BRI
- bridge
- broadband
- C-bit Coding Violation (CCV)
- C-bit Errored Seconds (CES)
- C-bit Severely Errored Seconds (CSES)
- CDPD
- Central Office (CO)
- Challenge Handshake Authorization Protocol (CHAP)
- channel
- Channel Associated Signaling (CAS)
- CIDR
- Circuit Identifier
- Clear Channel
- CLI
- Classless Routing
- cold-standby
- Command Line
- Community Name
- Constant Bit Rate (CBR)
- CSU
- Customer Premise Equipment (CPE)
- Cyclic Redundancy Check (CRC)
- D4 Superframe (SF)
- Data Terminal Equipment (DTE)
- DDS
- DHCP
- download
- Drop & Insert (D&I)
- DS0
- DS1
- DS3
- DSU/CSU
- Dual Tone Multi- Frequency (DTMF)
- Dynamic Host Configuration Protocol (DHCP)
- E&M Signaling
- Earth ground
- Electro- magnetic Interference (EMI)
- Ethernet
- Facilities Data Link (FDL)
- File Transfer Protocol (FTP)
- filter
- frame
- frame relay
- FX
- FXO
- FXS
- gateway
- ground
- ground start (GS)
- GUI
- High Density Bipolar 3 (HDB3)
- High level Data Link Control (HDLC)
- hop
- host
- hot-standby
- hub
- IP
- Integrated Services Digital Network (ISDN)
- ISDN BRI
- internet
- Internet Protocol (IP)
- IP address
- jitter
- kbps
- kilobyte (kb)
- LAN (Local Area Network)
- Line Coding Violation (LCV)
- Line Errored Seconds (LES)
- Line Interface Unit (LIU)
- LLC
- LMI
- LMU
- LOF
- LOS
- loop back test
- loop start (LS)
- loopback
- LULT
- LUNT
- Management Information Base (MIB)
- Media Access Control (MAC)
- Mean Time Between Failures (MTBF)
- megabyte (MB)
- modem
- multiplexor
- network
- Network Address Translation (NAT)
- OOS
- OCU-DP
- P-bit Coding Violation (PCV)
- P-bit Errored Seconds (PES)
- P-bit Severely Errored Seconds (PSES)
- packet
- Packet InterNet Grouper (PING)
- Password Authentication Protocol (PAP)
- Peak Cell Rate (PCR)
- PLAR
- PMDL
- Point-to-Point Protocol (PPP)
- port
- protocol
- PVC
- RIP
- robbed bit
- router
- signal
- Simple Network Management Protocol (SNMP)
- slot
- span
- Spanning Tree
- star network
- static
- subnet mask
- subrate multiplexing
- subscriber line
- switch
- synchronous
- T1
- TBOS
- telnet
- TFTP
- Time Division Multiplexing (TDM)
- traffic
- Transmission Only (TO)
- trap
- Trivial File Protocol (TFTP)
- trunk
- trunk port
- upload
- V.90
- VC MUX
- Voice Over IP (VoIP)
- Wide Area Network (WAN)
- Wink
- Glossary
- Index

1-2 Axxius 800 - Release 2.2
Base Platform
Overview
Overview
The Axxius 800 Access Integration Platform solves today’s problems of multiple
boxes, scalability, space, power, and environmental constraints associated with
delivering voice and data services. The Axxius 800 defines a new level of functionality
and performance for the access needs of both wireless and wireline service providers,
and enables them to groom and deliver services for more revenue at dramatically lower
costs. Its versatility and scalability in a two rack unit design offers the highest density
and most flexibility to meet the complex network challenges of today and tomorrow.
The Axxius 800's enclosure, commons, and many of the service cards are temperature-
hardened and designed to withstand the extreme conditions found in service provider
equipment locations. It is a carrier-quality platform with full redundancy to protect
critical networks. The Axxius 800 Base Platform includes 1+1 Power Supply slots, 1+1
Controller card slots, 1+1 Broadband Interface slots, a Control Panel Interface card,
eight universal Service card slots, and one Low-Speed Interface Protection card slot.
The rear panel of the Axxius chassis is connectorized and designed for the tight
confines of cell sites, outside cabinets, collocations, or central offices. Dual-feed rear
power connectors support power supply redundancy, and inputs for clocking and alarm
connections are easily accessible. In addition, front RJ-48C and rear wire-wrap
terminals provide easy connection points to DSX patch panels from any of the eight
Service card slots.
The DS1 and DS3 Controllers manage the Service cards, providing the physical,
electrical, and logical connections to deliver a complete, integrated, single-unit
solution. The following are the supported Service cards:
l 8-Channel FXO Voice Service card
l Dual V.35/.54 Service card (hardened)
l ISDN BRI Service cards
l OCU-DP Service cards
l Quad DS1 ADPCM Service card (hardened)
l Quad DS1/E1 Service Card (hardened) - E1 supported in future release
l Quad T1 Service card (hardened)
l Single-Channel POTS Service card (hardened)
l Single-Channel POTS Service card with an integrated V.34 modem
l Terminal Server Router (TSR) Service card (hardened)
l Low-Speed Interface Protection card (hardened)