Axxius 800 User Manual
Table Of Contents
- Axxius 800 User Manual
- Preface
- Table of Contents
- 1 - Base Platform
- 2 - Physical Installation
- 3 - Electrical Installation and Cabling
- 4 - Configuration
- 5 - CLI Commands
- Command Line Interface Help
- CLI Commands
- aco (Alarm Cut Off)
- add
- add (ds1) ais
- add (router) dhcp server option
- add (router) dns proxy
- add (router) remote
- add (router) snmp community
- add (router) snmp trap
- add (router) static dns host
- add (router) uploaduser
- add (router-lan) filter
- add (router-lan) secondary ip address
- add (router-lan) static
- add (router-wan) firewall
- add (router-wan) gre network
- add (router-wan) nat bypass
- add (router-wan) static
- add user
- alarms
- clear
- connect
- delete
- delete (ds1) ais
- delete (router) dhcp server option
- delete (router) dns proxy
- delete (router) remote
- delete (router) snmp community
- delete (router) snmp trap
- delete (router) static dns host
- delete (router) uploaduser
- delete (router-lan) filter
- delete (router-lan) secondary ip address
- delete (router-lan) static
- delete (router-wan) firewall
- delete (router-wan) gre network
- delete (router-wan) nat bypass
- delete (router-wan) static
- delete user
- disconnect
- exit
- install
- load
- log
- ping
- rename (router)
- reset
- restore
- rtrping
- set
- set alarms
- set autoexit
- set (bri)
- set (bri) mode
- set (bri) pmsync
- set cclabel
- set clock
- set clock (1 and 2)
- set date
- set (ds0)
- set (ds1)
- set (ds1 card)
- set (ds3)
- set ethernet ip address
- set external alarm
- set (fxo)
- set (fxsPS or fxsPSM)
- set id
- set idle
- set ip gateway
- set ipds0
- set key
- set login auth
- set login support
- set lsbackup
- set lsprotect enable/disable
- set lsprotect manual
- set lsprotect nonrevertive
- set lsprotect remove
- set lsprotect revertive
- set (ocudp) baud
- set (ocudp) loopback
- set (ocudp) loopdetect
- set (ocudp) mvec
- set (ocudp) secondary
- set (ocudp) selftest
- set (ocudp) up/down
- set (router) autologout
- set (router) default
- set (router) dhcp
- set (router) dns
- set (router) enhanced security
- set (router) lmi
- set (router) lmi poll
- set (router) login auth
- set (router) login prompt
- set (router) ntp
- set (router) password
- set (router) port
- set (router) ppp auth
- set (router) ppp security
- set (router) proxy
- set (router) reboot
- set (router) rip
- set (router) snmp
- set (router) stp
- set (router) syslog
- set (router-lan) filter forward
- set (router-lan) framing
- set (router-lan) gateway
- set (router-lan) ip address
- set (router-lan) ipx network
- set (router-lan) phy
- set (router-lan) rip
- set (router-lan) stp
- set (router-lan) up/down
- set (router-trunk) encapsulation
- set (router-trunk) multilink group
- set (router-trunk) speed
- set (router-trunk) up/down
- set (router-wan) dlci
- set (router-wan) gre
- set (router-wan) ip
- set (router-wan) ip address
- set (router-wan) ipx
- set (router-wan) nat
- set (router-wan) other
- set (router-wan) ppp
- set (router-wan) rip
- set (router-wan) stp
- set (router-wan) trunk
- set (router-wan) up/down
- set screen
- set snmp
- set time
- set user
- set (v35)
- set (v54)
- set verification
- show
- show (adpcm)
- show autoexit
- show (bri)
- show cclabels
- show clock
- show connect
- show connect adpcm
- show date
- show (ds0)
- show (ds1)
- show (ds3)
- show ethernet
- show external alarms
- show (fxo)
- show (fxsPS or fxsPSM)
- show id
- show image
- show impedance
- show ip
- show ipds0
- show login
- show lsprotect
- show ntp
- show (ocudp)
- show radius
- show (router)
- show (router) dhcp
- show (router) dns
- show (router) dns proxy
- show (router) lmi
- show (router) login
- show (router) ntp
- show (router) port
- show (router) ppp
- show (router) rip
- show (router) snmp
- show (router) stp
- show (router) syslog
- show (router) uploaduser
- show (router-lan)
- show (router-lan) filter
- show (router-lan) static
- show (router-lan) stp
- show (router-wan)
- show (router-wan) firewall
- show (router-wan) nat bypass
- show (router-wan) ppp
- show (router-wan) static ip address
- show (router-wan) static ip network
- show (router-wan) static ipx network
- show (router-wan) static mac address
- show (router-wan) static nat address
- show (router-wan) stp
- show (router-wan) trunk
- show screen
- show snmp
- show syslog
- show time
- show users
- show (v35)
- show (v54)
- status
- status (adpcm)
- status (adpcm) performance
- status (adpcm) performance history
- status (bri)
- status (bri) performance
- status (bri) performance history
- status clock
- status (ds0)
- status (ds1)
- status (ds1) performance
- status (ds1) performance history
- status (ds3)
- status (ds3) performance
- status (ds3) performance history
- status equipment
- status (fxo)
- status (fxsPS or fxsPSM)
- status ipds0
- status lsprotect
- status (ocudp)
- status (ocudp) performance
- status (ocudp) performance history
- status (router)
- status (router-lan)
- status (router-trunk)
- status sessions
- status (v54)
- store
- switch
- telnet
- trace route
- 6 - DS1 Controller Card
- 7 - DS3 Controller Card
- 8 - FXO Voice Card
- 9 - ISDN BRI Card
- 10 - OCU-DP Card
- 11 - Single Channel POTS Cards
- 12 - Power Supply
- 13 - Quad DS1 ADPCM Card
- 14 - Quad T1 & Quad DS1/E1 Card
- 15 - Terminal Server Router Card
- 16 - V.35/.54 Card
- 17 - Low Speed Protection Card
- 18 - Maintenance
- A - Regulatory Approvals
- B - SNMP Interface
- C - Loopback Tests
- Alarms
- Logs
- Status and Performance
- Overview
- DS1 Loopbacks
- V.35 Loopbacks
- V.35/V.54 Loop
- V.35/V.54 Service Card Description
- V.54 Loop
- V.54 Equipment Loopback
- 10Base-T
- 100Base-TX
- ADPCM
- Annex D
- Analog
- authentication
- authorization
- B-channel
- B8ZS
- backplane
- bandwidth
- Basic Rate Interface (BRI)
- BER
- BERT
- bipolar
- Bipolar Violation (BPV)
- bit
- Bit Error Rate Test (BERT)
- bit robbing
- bps
- BPV
- BRI
- bridge
- broadband
- C-bit Coding Violation (CCV)
- C-bit Errored Seconds (CES)
- C-bit Severely Errored Seconds (CSES)
- CDPD
- Central Office (CO)
- Challenge Handshake Authorization Protocol (CHAP)
- channel
- Channel Associated Signaling (CAS)
- CIDR
- Circuit Identifier
- Clear Channel
- CLI
- Classless Routing
- cold-standby
- Command Line
- Community Name
- Constant Bit Rate (CBR)
- CSU
- Customer Premise Equipment (CPE)
- Cyclic Redundancy Check (CRC)
- D4 Superframe (SF)
- Data Terminal Equipment (DTE)
- DDS
- DHCP
- download
- Drop & Insert (D&I)
- DS0
- DS1
- DS3
- DSU/CSU
- Dual Tone Multi- Frequency (DTMF)
- Dynamic Host Configuration Protocol (DHCP)
- E&M Signaling
- Earth ground
- Electro- magnetic Interference (EMI)
- Ethernet
- Facilities Data Link (FDL)
- File Transfer Protocol (FTP)
- filter
- frame
- frame relay
- FX
- FXO
- FXS
- gateway
- ground
- ground start (GS)
- GUI
- High Density Bipolar 3 (HDB3)
- High level Data Link Control (HDLC)
- hop
- host
- hot-standby
- hub
- IP
- Integrated Services Digital Network (ISDN)
- ISDN BRI
- internet
- Internet Protocol (IP)
- IP address
- jitter
- kbps
- kilobyte (kb)
- LAN (Local Area Network)
- Line Coding Violation (LCV)
- Line Errored Seconds (LES)
- Line Interface Unit (LIU)
- LLC
- LMI
- LMU
- LOF
- LOS
- loop back test
- loop start (LS)
- loopback
- LULT
- LUNT
- Management Information Base (MIB)
- Media Access Control (MAC)
- Mean Time Between Failures (MTBF)
- megabyte (MB)
- modem
- multiplexor
- network
- Network Address Translation (NAT)
- OOS
- OCU-DP
- P-bit Coding Violation (PCV)
- P-bit Errored Seconds (PES)
- P-bit Severely Errored Seconds (PSES)
- packet
- Packet InterNet Grouper (PING)
- Password Authentication Protocol (PAP)
- Peak Cell Rate (PCR)
- PLAR
- PMDL
- Point-to-Point Protocol (PPP)
- port
- protocol
- PVC
- RIP
- robbed bit
- router
- signal
- Simple Network Management Protocol (SNMP)
- slot
- span
- Spanning Tree
- star network
- static
- subnet mask
- subrate multiplexing
- subscriber line
- switch
- synchronous
- T1
- TBOS
- telnet
- TFTP
- Time Division Multiplexing (TDM)
- traffic
- Transmission Only (TO)
- trap
- Trivial File Protocol (TFTP)
- trunk
- trunk port
- upload
- V.90
- VC MUX
- Voice Over IP (VoIP)
- Wide Area Network (WAN)
- Wink
- Glossary
- Index

PREFACE
Preface
Compliance
Safety
The Axxius 800 is certified by Underwriters Laboratories and is in compliance with UL60950, 3rd Edition;
Safety of Information Technology Equipment and CSA/C22.2 No 60950.
FCC Requirements, Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device pursuant
to Part 15 of the Federal Communications Rules. These limits are designed to provide reasonable
protection against harmful interference when equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in
accordance with the instruction manual may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at the user’s own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Requirements, Part 68
This equipment complies with Part 68 of the Federal Commission Rules. On the outside surface of this
equipment is a label that contains, among other information, the FCC registration number, Facility
Interface Code (FIC) and Service Order Code (SOC). This information must be provided to the telephone
company.
FCC Registration Number: US:2Z6MF03B800
Ringer Equivalence: 0.3B REN
Service Center in the USA: Carrier Access Corporation, 5395 Pearl Parkway, Boulder, CO 80301-2490