Axxius 800 User Manual

Axxius 800 - Release 2.2 5-131
CLI Commands
set
set (router) reboot
Use the set (router) reboot command to set automatic reboot after an upload of code or
configuration file.
Syntax: set {rtr_card-addr} reboot {code|config}
{disable|enable}
Example: set 5 reboot both disable
Disable automatic reboot after upload for the Router in slot 5.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{code|config}
{disable|enable}
set (router) rip
Use the set (router) rip command to specify RIP packets to transmit and receive.
Syntax: set {rtr_card-addr} rip {recv|send} {v1|v2|v1and2}
Example: set 3 rip recv v1
The example will configure receive RIP on the Router card in slot 3 to V1.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{recv|send}
{v1|v2|v1and2}
code Automatic reboot after code upload
config Automatic reboot after configuration upload
disable Will disable automatic reboot
enable Will enable the automatic reboot after upload of a file
recv Set RIP receive version
send Set RIP send version
v1 Set RIP to version 1
v2 Set RIP to version 2
v1and2 Set RIP to version 1 and version 2