Axxius 800 User Manual

Axxius 800 - Release 2.2 5-93
CLI Commands
set
set lsprotect enable/disable
Use the set lsprotect enable/disable command to set the global enable or disable the Low
Speed Protection options on the system.
Syntax: set lsprotect {disable|enable}
Example: set lsprotect disable
{disable|enable}
set lsprotect manual
Use the set lsprotect manual command to set manual mode control for protected ports. Note:
this command is effective only if lsprotect is enabled (set lsprotect enable).
Syntax: set lsprotect {slot:port} manual
{disable|enable|release|switchback|switchover} [hold]
Example: set lsprotect 5:1 manual enable
{slot:port}
The {slot:port} address of the protected port to be configured.
{disable|enable|release|switchback|switchover}
disable disable Low Speed Protection on the Axxius system
enable enable Low Speed Protection on the Axxius system
slot Slot number (1-8) where a Quad T1 card is located
port Port number or range (1-4)
disable Disables protection for protected port(s)
enable Enables protection for protected port(s) that have been automatically or
manually disabled.
release Releases manual hold for protected port(s).
switchback Switches protected port(s) back to home circuit(s).
[hold] Holds manual switchbacks in-force until user releases hold.
switchover Manually switches protected ports to backup circuit(s).
[hold] Holds manual switchbacks in-force until user releases hold.