Axxius 800 User Manual

5-66 Axxius 800 - Release 2.2
CLI Commands
reset
reset
reset (controller)
Use the reset (controller) command to reboot the system. Reset alone will reboot the entire
system.
Syntax: reset [ctrlr-addr|active|standby]
Example: reset a1
Will reset the controller in the controller slot 1.
Do you really want to reset (y/n)? y
**** System Boot ****
Copyright 1999,2000 Carrier Access Corporation.
{ctrlr_card-addr|active|standby}
WARNING! THE COMMANDS reset AND reset active ARE SERVICE AFFECTING
COMMANDS.
reset (router)
Use the reset (router) command to reboot the Router. All new configuration since the last
reset will be in use.
Syntax: reset {rtr_card-addr}
Example: reset 1
The example will reset the Router card in slot 1.
Do you really want to do this ? y
OK
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
ctrlr_card-addr Resets the Controller in the defined slot number (a1 or a2)
active Resets the active Controller
standby Resets the standby Controller