Axxius 800 User Manual

5-58 Axxius 800 - Release 2.2
CLI Commands
disconnect
delete user
The delete user command will remover a user created by the add user command.
Syntax: delete user {"user-name"}
Example: delete user "jsmith"
{"user-name"}
The user-name is an existing user ID in the system. This name must be enclosed in quotes.
disconnect
disconnect
Remove a connection created using the connect command.
Syntax: disconnect
{slot|slot:port|slot:port:channel|slot:port:trunk}
Example: disconnect A:2:1-24 3:1
Disconnects all 24 channels on port address #2 (DS1) on the controller card (slot
A) to port address #1 V.35 in slot 3.
NOTE: The operator can remove connections for all of a slot {slot}, a port
within a slot {slot:port}, or for specific channel {slot:port:channel}
{slot|slot:port|slot:port:channel|slot:port:trunk}
slot A for the controller card, or 1-8 for service cards.
port Port number or range.
channel Channel number or range, for T1 ports.
trunk Trunk number for this port, 1-24.