Axxius 800 User Manual

5-24 Axxius 800 - Release 2.2
CLI Commands
add
{service}
{dest-ip-addr/bits}
The destination IP Address and number of significant bits. The IP Address is in the form of
xxx.xxx.xxx.xxx, where xxx is between 0-255. The address "0.0.0.0/0" matches any
address.
finger Display information about users
ftp File Transfer Protocol
gopher Document search and retrieval
http World Wide Web
icmp Internet Control Message Protocol
nntp Network News Transfer
ping ICMP echo request/reply
pop3 Post Office Protocol Version 3
smtp Simple Mail Transfer
snmp Simple Network Management Protocol
tcp Transmission Control Protocol
port number (0 - 65535) or range
telnet User interface to remote unit
udp User Datagram Protocol
port number (0 - 65535) or range
wais Wide Area Information Services
protocol Enter a protocol number. Note: for list of protocols and numbers see,
Protocol Number in Firewall Filters on page D-2.
{protocol-number}= number between 0-255 0 = any protocol
dest-ip-addr Enter the IP Address of the local device or network that this rule will
affect. If you enter the address of a local device, this rule will affect
only the session establishments of the local device and the
destination address entered in the Remote IP Address/Network field,
below. The IP Address is in the form of xxx.xxx.xxx.xxx, where xxx
is between 0-255.
bits Use this field to identify the number of bits, from left to right that
will be used to match the IP Address field within the data packet.
Range is between 1-32.