Operating instructions

7-32 Commissioning and Parameterization Rexroth IndraDrive
DOK-INDRV*-FU*********-IB01-EN-P
• Press Prog
+
key.
Basic parameters are loaded.
• If you don't want to load basic parameters:
Press
key.
You can save the parameter set of a drive controller on the comfort
control panel and then the load the parameter set which was saved to
another drive controller. The parameter set which was saved contains the
parameters from the list of backup parameters.
Requirements
Note: To use this function you need a comfort control panel of
version VCP01.2BWA-TS-NN-FW (see type plate of comfort
control panel).
1: Type plate on the back of the comfort control panel
Fig. 7-29: Type plate of the comfort control panel
To use this function
• the functional package "Open-Loop" must be active in the firmware
which is used and
• the drive controller with comfort control panel plugged must have
booted
• Go to main screen.
By pressing key
several times you get to main screen. By means of
Esc key, you might possibly have to exit editing mode before.
• Press key
.
Mode selection is displayed.
• Select Parameter management
• Press key
.
Parameter mode is automatically displayed. Following display appears:
Save/Load Parameters (Copying
Parameter Sets)
Save Parameters