Operating instructions

7-30 Commissioning and Parameterization Rexroth IndraDrive
DOK-INDRV*-FU*********-IB01-EN-P
• Select Change single parameter
• Press
key.
The following display appears:
Fig. 7-24: Select parameter
• With keys Prog
+
, Mon, Enter, , , enter desired parameter (see
also example below):
Prog
+
, Mon: change setting
Enter,
, : move cursor to the left or to the right
Fig. 7-25: Enter parameter
• After desired parameter has been entered:
Press Enter key.
• Press Esc key.
• Press key
.
Value of parameter is displayed.
• Press Esc key.
To display name and unit of parameter:
• Press key
.
Name and unit of parameter are displayed.
• Press key
to go to previous display.
Example:
Last parameter displayed was S-0-0383.
Parameter P-0-1222 is to be displayed.
• S
key Prog
+
P key Enter
• 0
key Enter
• 0
key Prog
+
1 key
• 3 key Mon 2 key
• 8 key Mon 7 … key Mon 2 key
• 3 key Mon 2 key
• Press Enter key.
• Press Esc key.
• Press
key.
Value of parameter P-0-1222 is displayed.
• Press Esc key.