Operating instructions

Rexroth IndraDrive Commissioning and Parameterization 7-29
DOK-INDRV*-FU*********-IB01-EN-P
• Go to main screen.
By pressing key
several times you get to main screen. By means of
Esc key, you might possibly have to exit editing mode before.
• Press key
.
Mode selection is displayed.
• Select Parameterization.
• Press key
.
Parameter mode is automatically displayed. Following display appears:
Fig. 7-22: Parameterization
When drive controller was in status AF (drive enable), following display
appears:
Fig. 7-23: Error message when switching operating mode/parameter mode
Switch off drive enable and repeat procedure.
Change Single Parameter