Operating instructions

Rexroth IndraDrive Mounting and Installation 6-79
DOK-INDRV*-FU*********-IB01-EN-P
1. By means of supplied screws, fasten shield angle steel to bottom of
drive controller.
2. Fix support to shield angle steel as required.
hrau
shield angle steel
support
clip
methode of installation,
for the motor cable selectable
MZZU0012EN00.FH9
PE
Fig. 6-103: Shielding plate HAS02.1-004-NNN-NN at the bottom of the drive
controller HCS03.1E-W0070
3. Fix shield of motor cable to shielding plate with a clip.
Note: Adapt the size of the clip to the motor cable cross section.
1. Hang up support at guide section at bottom of drive controller and
fasten it by means of supplied screws.
2. Screw shielding plate to shield angle steel.
According to required motor cable routing, it is possible to mount angle
plate for shield connection in different positions:
• motor cable routed in parallel or
• 45° to bottom of drive controller.
Mounting Shield Connection
HAS02.1-004-NNN-NN to Drive
Controller HCS03.1E-W0070:
Mounting Shield Connection
HAS02.1-005-NNN-NN to Drive
Controller HCS03.1E-W0100 /
150: