BROADway System Installation Manual

BROADway - Release 4.00 3-31

Configuration

Upgrading System Software

4. To complete the software upgrade, use the set-upgrade command to decompress the

software image, copy it to the backup NSP101 and reboot the BROADway system:

NSP1> set-upgrade::nsp:1234::bw308,all;

Sending file /FLASH/bw308.zip to peer

NSP.....................

SET-BOOT bw308 command executing in peer

NSP..................

SET-BOOT bw308 command executing in local NSP

INIT-SYS command executing in peer NSP

/* LOCAL SYSTEM REBOOTING */

2003-04-08 12:58:42

M 99 COMPLD

NSP-1,

;

CAUTION! THE SET-UPGRADE COMMAND CAUSES THE SYSTEM TO AUTOMATICALLY

REBOOT FROM THE SOFTWARE IMAGE SPECIFIED IN THE COMMAND LINE. THIS IMAGE MUST

HAVE PREVIOUSLY BEEN DOWNLOADED USING FTP TO THE FLASH MEMORY ON THE

BROAD

WAY SYSTEM. SET-UPGRADE AUTOMATICALLY UNZIPS THE SOFTWARE IMAGE INTO

THE EXECUTABLE APPLICATION FILES THAT THE BROADWAY SYSTEM WILL USE TO OPERATE.

To upgrade a BROADway system with a single NSP only, use the following format for the

set-upgrade command:

NSP1> set-upgrade::nsp:1234::bw308;