System information

Adit 3000 CLI - Release 1.6 24-5
Configuration - Voice Service SIP Mode
end
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file. Note: This command can be entered in any configuration mode with the same result.
Syntax: (config-voice-serv-sip)# end
Example: (config-voice-serv-sip)# end
#
Supported Platforms:
Adit 3104, Adit 3500
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax: (config-voice-serv-sip)# exit
Example: (config-voice-serv-sip)# exit
(config)#
Supported Platforms:
Adit 3104, Adit 3500
fax-protocol-t38 ecs
Use the Voice Service SIP fax-protocol-t38 ecs command to configure fax Error Correction Scheme
parameter.
Syntax: (config-voice-serv-sip)# fax-protocol-t38 ecs {none|redundant}
Example: (config-voice-serv-sip)# fax-protocol-t38 ecs redundant
Syntax Descriptions:
Supported Platforms:
Adit 3104, Adit 3500
Variable Definition
none Set error correction to none.
redundant Set error correction to redundant. Default.