System information

23-8 Adit 3000 CLI - Release 1.6
Configuration - Voice Port Trunk Mode
no commands
no commands
no comfort-noise
Use the Voice Port Trunk no comfort-noise command to disable comfort noise. To enable remote
access, see comfort-noise command on page 23-2.
Syntax: (config-vport-trk-{n})# no comfort-noise
Example: (config-vport-trk-1)# no comfort-noise
Supported Platforms:
Adit 3500
no connection t1
Use the Voice Port Trunk no connection t1 command to remove a T1 connection. To enter the T1
connection configuration mode, see connection t1 command on page 23-2.
Syntax: (config-vport-trk-{n})# no connection t1 port
Example: (config-vport-trk-1)# no connection t1 2
Supported Platforms:
Adit 3500
no digit-map
Use the Voice Port Trunk no digit-map command to disable digit map on the trunk. To configure
digit map, see digit-map command on page 23-3.
Syntax: (config-vport-trk-{n})# no digit-map
Example: (config-vport-trk-1)# no digit-map
Supported Platforms:
Adit 3500
Field Definition
port Enter a current T1 connection. T1 port range 1-4.