System information

22-4 Adit 3000 CLI - Release 1.6
Configuration - Voice Port FXS Mode
echo-cancel
echo-cancel
Use the Voice Port FXS echo-cancel command to enable Echo Cancellation on this trunk. To to disable
Echo Cancellation, see no echo-cancel command on page 22-6
Syntax: (config-vport-fxs-{n})# echo-cancel enable
Example: (config-vport-fxs-1)# echo-cancel enable
Supported Platforms:
Adit 3104, Adit 3500
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file.
Syntax: (config-vport-fxs-{n})# end
Example: (config-vport-fxs-1)# end
#
Supported Platforms:
Adit 3104, Adit 3500
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax: (config-vport-fxs-{n})# exit
Example: (config-vport-fxs-1)# exit
(config)#
Supported Platforms:
Adit 3104, Adit 3500