System information

19-4 Adit 3000 CLI - Release 1.6
Configuration - VLAN Mode
no command
no command
no port-dot1q
Use the VLAN no port-dot1q command to disable dot1q tagging for the port. By default, VLAN
tagging is disabled on a LAN port. In this default state, if the port receives a VLAN tagged frame,
it will ignore the VLAN header and will process the ingress frames as a regular Ethernet frame. The
VLAN tag will not be altered.
Note: Ingress port is a port receiving frames from a source external to the switch. Egress port is a
port forwarding frames to another port(s) in the switch.
To set the port to VLAN aware mode, see port-dot1q command on page 19-4.
Syntax: (config-vlan)# no port-dot1q ethernet port
Example: (config-vlan)# no port-dot1q ethernet 1.1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
port-dot1q
Use the VLAN port-dot1q command to enable dot1q tagging for the port. If VLAN tagging is enabled
on a port, the port will forward any untagged or priority tagged frames with a VID equal to the ingress
port’s PVID and the priority of the tagged frame will remain unchanged. See the port-priority
command, on page 19-5, to set the priority of the port.
Note: Ingress port is a port receiving frames from a source external to the switch. Egress port is a port
forwarding frames to another port(s) in the switch.
To clear the dot1q for the port, see no port-dot1q command on page 19-4.
Syntax: (config-vlan)# port-dot1q ethernet port
Example: (config-vlan)# port-dot1q ethernet 1.1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
port Ethernet port in the form {port}.{sub-interface}.
Adit 3104 and Adit 3200 = 1.1, 1.2, 1.3, 1.4, 2.1
Adit 3500 = 1.1 and 2.1
Field Definition
port Ethernet port in the form {port}.{sub-interface}.
Adit 3104 and Adit 3200 = 1.1, 1.2, 1.3, 1.4, 2.1
Adit 3500 = 1.1 and 2.1