System information

Adit 3000 CLI - Release 1.6 16-13
Configuration - PPTPC Mode
no commands
no commands
no firewall
Use the PPTP Client no firewall command to disable the configured firewall. To enable the
firewall, see firewall command on page 16-3.
Syntax: (config-pptpc-{n})# no firewall
Example: (config-pptpc-1)# no firewall
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip address
Use the PPTP Client no ip address command to remove the IP address assigned to the port. To set
the Serial IP address, see ip address command on page 16-5.
Syntax: (config-pptpc-{n})# no ip address address
Example: (config-pptpc-1)# no ip address 192.168.1.100
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
no ip default-route
Use the PPTP Client no ip default-route command to disable the default route. To set the default
IP address, see ip default-route command on page 16-5.
Syntax: (config-pptpc-{n})# no ip default-route
Example: (config-pptpc-1)# no ip default-route
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf authentication
Use the PPTP Client no ip ospf authentication command to disable the authentication method for
this Serial interface. To enable the authentication type for this interface see ip ospf authentication
command on page 16-6.
Syntax: (config-pptpc-{n})# no ip ospf authentication
Example: (config-pptpc-1)# no ip ospf authentication
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
address Enter the IP address to remove.