System information

Adit 3000 CLI - Release 1.6 14-19
Configuration - L2TPC Mode
no commands
no ppp time-btwn-reconnect
Use the L2TPC no ppp time-btwn-reconnect command to reset this time to the default settings.
To set the interval between reconnect attempts, see ppp time-btwn-reconnect command on
page 14-22.
Syntax: (config-l2tpc-{n})# no ppp time-btwn-reconnect
Example: (config-l2tpc-1)# no ppp time-btwn-reconnect
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ppp username
Use the L2TPC no ppp username command remove the PPP username. To set a PPP user, see ppp
username command on page 14-22.
Syntax: (config-l2tpc-{n})# no ppp username username
Example: (config-l2tpc-1)# no ppp username test-user-name
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no schedule-availability
Use the L2TPC no schedule-availability command to disable a schedule rule. To add a rule, see
schedule-availability command on page 14-23.
Syntax: (config-l2tpc-{n})# no schedule-availability
Example: (config-l2tpc-1)# no schedule-availability
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no shutdown
Use the L2TPC no shutdown command to set the Serial port up (In-Service). To set the interface
down (Out-of-Service), see shutdown command on page 14-23.
Syntax: (config-l2tpc-{n})# no shutdown
Example: (config-l2tpc-1)# no shutdown
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500