System information

Adit 3000 CLI - Release 1.6 14-17
Configuration - L2TPC Mode
no commands
no ip route
Use the L2TPC no ip route command remove an IP route. To add a route, see ip route command
on page 14-11.
Syntax: (config-l2tpc-{n})# no ip route dest-ip-addr gateway
Example: (config-l2tpc-1)# no ip route 192.168.100.200 192.168.100.254
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip secondary-dns
Use the L2TPC no secondary-dns command to disable the secondary DNS. To enable the
secondary DNS, see ip secondary-dns command on page 14-12.
Syntax: (config-l2tpc-{n})# no ip secondary-dns
Example: (config-l2tpc-1)# no ip secondary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ppp authentication
Use the L2TPC no ppp authentication command disable PPP authentication. To enable PPP
authentication, see ppp authentication command on page 14-20.
Syntax: (config-l2tpc-{n})# no ppp authentication
Example: (config-l2tpc-1)# no ppp authentication
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ppp encryption
Use the L2TPC no ppp encryption command to disable PPP encryption. To enable PPP
encryption, see ppp encryption command on page 14-20.
Syntax: (config-l2tpc-{n})# no ppp encryption
Example: (config-l2tpc-1)# no ppp encryption
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
dest-ip-addr Enter destination IP address to remove.
gateway Enter gateway IP address to remove.