System information

14-16 Adit 3000 CLI - Release 1.6
Configuration - L2TPC Mode
no commands
no ip ospf retransmit-interval
Use the L2TPC ip ospf retransmit-interval command to restore the default value of 5 seconds. To
define the interval of time between link state advertisement retransmissions for adjacencies
belonging to the interface, see ip ospf retransmit-interval command on page 14-9.
Syntax: (config-l2tpc-{n})# no ip ospf retransmit-interval
Example: (config-l2tpc-1)# no ip ospf retransmit-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf transmit-delay
Use the L2TPC no ip ospf transmit-delay command to restore the default value of 1 second. To
define the estimated time to transmit a link state update packet on the interface, see ip ospf transmit-
delay command on page 14-9.
Syntax: (config-l2tpc-{n})# no ip ospf transmit-delay
Example: (config-l2tpc-1)# no ip ospf transmit-delay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip primary-dns
Use the L2TPC no primary-dns command to disable the primary DNS. To set the DNS primary
IP address, see ip primary-dns command on page 14-10.
Syntax: (config-l2tpc-{n})# no ip primary-dns
Example: (config-l2tpc-1)# no ip primary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip rip
Use the L2TPC no ip rip command to disable RIP on this interface. To enable RIP, see ip rip
command on page 14-10.
Syntax: (config-l2tpc-{n})# no ip rip
Example: (config-l2tpc-1)# no ip rip
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500