System information

Adit 3000 CLI - Release 1.6 14-15
Configuration - L2TPC Mode
no commands
no ip ospf hello-interval
Use the L2TPC no ip ospf hello-interval command to reset the interval of time to the default setting
of the path cost to the default setting of 10 seconds. To define the interval of time between hello
packets that the Adit 3000 sends on the interface, see ip ospf hello-interval command on page 14-8.
Syntax: (config-l2tpc-{n})# no ip ospf hello-interval
Example: (config-l2tpc-1)# no ip ospf hello-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf message-digest-key
Use the L2TPC no ip ospf message-digest-key command to remove an old MD5 key. To enable
OSPF MD5 (Message-Digest) authentication, see ip ospf message-digest-key command on
page 14-8.
Syntax: (config-l2tpc-{n})# no ip ospf message-digest-key key-id
Example: (config-l2tpc-1)# no ip ospf message-digest-key 1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf priority
Use the L2TPC no ip ospf priority command to set the router priority to the default setting of
priority 1. To set the router priority, which determines the designated router for this network, see ip
ospf priority command on page 14-9.
Syntax: (config-l2tpc-{n})# no ip ospf priority
Example: (config-l2tpc-1)# no ip ospf priority
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
key-id Enter an ID for this key. Range is 1-255.