System information

14-14 Adit 3000 CLI - Release 1.6
Configuration - L2TPC Mode
no commands
no ip ospf authentication-key
Use the L2TPC no ip ospf authentication-key command to remove a password to be used by
neighboring routers, that are using OSPF’s simple password authentication.To assign a password,
see ip ospf authentication-key command on page 14-7.
Syntax: (config-l2tpc-{n})# no ip ospf authentication
Example: (config-l2tpc-1)# no ip ospf authentication-key
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf cost
Use the L2TPC no ip ospf cost command to reset the cost path to the default setting of 0. To define
the cost of sending a packet on this Serial interface, see ip ospf cost command on page 14-7.
Syntax: (config-l2tpc-{n})# no ip ospf cost
Example: (config-l2tpc-1)# no ip ospf cost
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf dead-interval
Use the L2TPC no ip ospf dead-interval command to reset the interval of time to the default setting
of 40 seconds. To define the interval of time that no hello packets have been seen before neighbors
declare the router down, see ip ospf dead-interval command on page 14-7.
Syntax: (config-l2tpc-{n})# no ip ospf dead-interval
Example: (config-l2tpc-1)# no ip ospf dead-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf disable
Use the L2TPC no ip ospf disable command to enable OSPF processing on this interface. To
disable OSPF on this interface, see ip ospf disable command on page 14-8.
Syntax: (config-l2tpc-{n})# ip ospf disable all
Example: (config-l2tpc-1)# ip ospf disable all
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500