System information

Adit 3000 CLI - Release 1.6 14-13
Configuration - L2TPC Mode
no commands
no commands
no firewall
Use the L2TPC no firewall command to disable the configured firewall. To enable the firewall, see
firewall command on page 14-3.
Syntax: (config-l2tpc-{n})# no firewall
Example: (config-l2tpc-1)# no firewall
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip address
Use the L2TPC no ip address command to remove the IP address assigned to the port. To set the
Serial IP address, see ip address command on page 14-5.
Syntax: (config-l2tpc-{n})# no ip address address
Example: (config-l2tpc-1)# no ip address 192.168.1.100
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
no ip default-route
Use the L2TPC no ip default-route command to disable the default route. To set the default IP
address, see ip default-route command on page 14-5.
Syntax: (config-l2tpc-{n})# no ip default-route
Example: (config-l2tpc-1)# no ip default-route
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf authentication
Use the L2TPC no ip ospf authentication command to disable the authentication method for this
Serial interface. To enable the authentication type for this interface see ip ospf authentication
command on page 14-6.
Syntax: (config-l2tpc-{n})# no ip ospf authentication
Example: (config-l2tpc-1)# no ip ospf authentication
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
address Enter the IP address to remove.