System information

Adit 3000 CLI - Release 1.6 13-21

Configuration - IPSec Mode

transform-set

Use the IPSec transform-set command to set the allowable encryption methods, authentication

protocols and to enable compression during automatic key exchange. To disable encryption/

authentication/compression, see no transform-set command on page 13-17.

Syntax: (config-int-ser-{n})# transform-set {ah-md5|ah-sha|esp-3des|

|ipcomp}

Example: (config-int-ser-1)# transform-set esp-aes

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500

Field Definition

ah-md5 Authentication Header transform using MD5 authentication. Default.

ah-sha Authentication Header transform using Secure Hash Algorithm

(SHA1) authentication. Default.

esp-aes Encapsulating Security Payload (ESP) encryption transform using

Advanced Encryption Standard (AES) 128-bit encryption.

esp-aes192 Encapsulating Security Payload (ESP) encryption transform using

Advanced Encryption Standard (AES) 128-bit encryption.

esp-aes256 Encapsulating Security Payload (ESP) encryption transform using

Advanced Encryption Standard (AES) 256-bit encryption.

esp-des Encapsulating Security Payload (ESP) encryption transform using

Data Encryption Standard (DES) 56-bit encryption.

esp-3des Encapsulating Security Payload (ESP) encryption transform using

Data Encryption Standard (DES) 168-bit encryption.

esp-null Encapsulating Security Payload (ESP) encryption transform using no

encryption.

esp-md5 Encapsulating Security Payload (ESP) encryption transform using

Message-Digest Algorithm 5 (MD5) authentication. Default.

esp-sha Encapsulating Security Payload (ESP) encryption transform using

Secure Hash Algorithm (SHA1) authentication. Default.

ipcomp IP Payload Compression Protocol (IPComp) compression.