System information

Adit 3000 CLI - Release 1.6 13-13
Configuration - IPSec Mode
netbios remote-ip
netbios remote-ip
Use the IPSec netbios remote-ip command to set the remote broadcast address for NetBIOS.
Syntax: (config-int-ser-{n})# netbios remote-ip address
Example: (config-int-ser-1)# netbios remote-ip 192.168.1.200
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no commands
no aggressive-mode
Use the IPSec mode no aggressive-mode command to set to main mode, instead of aggressive mode.
To set to aggressive mode, see aggressive-mode command on page 13-2.
Syntax: (config-ipsec {n})# no aggressive-mode
Example: (config-ipsec-1)# no aggressive-mode
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no dpd-delay
Use the IPSec no dpd-delay command to reset the Dead Period Detection (DPD) delay back to the
default settings. To set the DPD delay, see dpd-delay command on page 13-4.
Syntax: (config-int-ser-{n})# no dpd-delay
Example: (config-int-ser-1)# no dpd-delay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no dpd-enable
Use the IPSec no dpd-enable command to disable Dead Period Detection (DPD). To enable DPD, see
dpd-enable command on page 13-4.
Syntax: (config-int-ser-{n})# no dpd-enable
Example: (config-int-ser-1)# no dpd-enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
address Enter the remote broadcast address.