System information

13-8 Adit 3000 CLI - Release 1.6
Configuration - IPSec Mode
ip rip
ip rip
ip rip enable
Use the IPSec ip rip enable command to enable RIP on this interface. To disable RIP, see no ip rip
command on page 13-15.
Syntax: (config-ipsec-{n})# ip rip enable
Example: (config-ipsec-1)# ip rip enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
ip rip receive-version
Use the IPSec ip rip receive-version command to configure the RIP receive messages on this
interface.
Syntax: (config-ipsec-{n})# ip rip receive-version {1|2|1or2|none}
Example: (config-ipsec-1)# ip rip receive-version none
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
ip rip send-version
Use the IPSec ip rip send-version command to configure the send RIP messages on this interface.
Syntax: (config-ipsec-{n})# ip rip send-version {1|2-bcast|2-mcast
|none}
Example: (config-ipsec-1)# ip rip send-version 2-bcast
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
1|2|1or2 Receive RIP version 1
Receive RIP version 2
Receive RIP version 1 and 2.
none Set RIP version to none.
Field Definition
1 Send RIP version 1.
2-bcast Send RIP version 2 - Broadcast.
2-mcast Send RIP version 2 - Multicast.
none Set RIP version to none.