System information

Adit 3000 CLI - Release 1.6 12-15
Configuration - Serial Interface Mode
no commands
no ip address
Use the Serial Interface no ip address command to remove the IP address assigned to the port. To
set the Serial IP address, see ip address command on page 12-6.
Syntax: (config-int-ser-{n})# no ip address address
Example: (config-int-ser-1)# no ip address 192.168.1.100
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip default-route
Use the Serial Interface no ip default-route command to disable the default route. To set the default
IP address, see ip default-route command on page 12-6.
Syntax: (config-int-ser-{n})# no ip default-route
Example: (config-int-ser-1)# no ip default-route
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf authentication
Use the Serial Interface no ip ospf authentication command to disable the authentication method
for this Serial interface. To enable the authentication type for this interface see ip ospf
authentication command on page 12-7.
Syntax: (config-int-ser-{n})# no ip ospf authentication
Example: (config-int-ser-{n})# no ip ospf authentication
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip ospf authentication-key
Use the Serial Interface no ip ospf authentication-key command to remove a password to be used
by neighboring routers, that are using OSPF’s simple password authentication.To assign a
password, see ip ospf authentication-key command on page 12-8.
Syntax: (config-int-ser-{n})# no ip ospf authentication
Example: (config-int-ser-1)# no ip ospf authentication-key
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
address Enter the IP address to remove.